These changes are the raw update to linux-4.4.6-rt14. Kernel sources

are taken from kernel.org, and rt patch from the rt wiki download page.

During the rebasing, the following patch collided:

Force tick interrupt and get rid of softirq magic(I70131fb85).

Collisions have been removed because its logic was found on the
source already.

Change-Id: I7f57a4081d9deaa0d9ccfc41a6c8daccdee3b769
Signed-off-by: José Pekkarinen <jose.pekkarinen@nokia.com>

1 files changed, 45 insertions, 0 deletions

diff --git a/kernel/Documentation/devicetree/bindings/i2c/i2c.txt b/kernel/Documentation/devicetree/bindings/i2c/i2c.txt
new file mode 100644
index 000000000..8a99150ac
--- /dev/null
+++ b/kernel/Documentation/devicetree/bindings/i2c/i2c.txt
@@ -0,0 +1,45 @@
+Generic device tree bindings for I2C busses
+===========================================
+
+This document describes generic bindings which can be used to describe I2C
+busses in a device tree.
+
+Required properties
+-------------------
+
+- #address-cells  - should be <1>. Read more about addresses below.
+- #size-cells     - should be <0>.
+- compatible      - name of I2C bus controller following generic names
+		    recommended practice.
+
+For other required properties e.g. to describe register sets,
+clocks, etc. check the binding documentation of the specific driver.
+
+The cells properties above define that an address of children of an I2C bus
+are described by a single value. This is usually a 7 bit address. However,
+flags can be attached to the address. I2C_TEN_BIT_ADDRESS is used to mark a 10
+bit address. It is needed to avoid the ambiguity between e.g. a 7 bit address
+of 0x50 and a 10 bit address of 0x050 which, in theory, can be on the same bus.
+Another flag is I2C_OWN_SLAVE_ADDRESS to mark addresses on which we listen to
+be devices ourselves.
+
+Optional properties
+-------------------
+
+These properties may not be supported by all drivers. However, if a driver
+wants to support one of the below features, it should adapt the bindings below.
+
+- clock-frequency	- frequency of bus clock in Hz.
+- wakeup-source		- device can be used as a wakeup source.
+
+- interrupts		- interrupts used by the device.
+- interrupt-names	- "irq" and "wakeup" names are recognized by I2C core,
+			  other names are left to individual drivers.
+
+Binding may contain optional "interrupts" property, describing interrupts
+used by the device. I2C core will assign "irq" interrupt (or the very first
+interrupt if not using interrupt names) as primary interrupt for the slave.
+
+Also, if device is marked as a wakeup source, I2C core will set up "wakeup"
+interrupt for the device. If "wakeup" interrupt name is not present in the
+binding, then primary interrupt will be used as wakeup interrupt.