summaryrefslogtreecommitdiffstats
path: root/VNFs/DPPD-PROX/parse_utils.c
AgeCommit message (Collapse)AuthorFilesLines
2020-05-29VLAN support with vdev devices + few other changesXavier Simonart1-3/+9
- vdev devices now support VLAN. - kernel tap device can be configured with a netmask (/24 was always used in previous version). - when sending a (fake) packet to the kernel, this packet will now not be routed by the kernel (i.e. it will leave through the interface configured by PROX). This might change in the futture when PROX supports multiple VLANs per port. But today it prevents ARP being sent on management interfaces. - Log error in case kernel unable to send packet. - Added support for comments (';') in lua sections. - Prevent duplication of local_ipv4 - should now be configured in port section local_ipv4 in core section still supported Change-Id: I8f9a40fe6ad6f3013ff91b58b44627c7f34081e6 Signed-off-by: Xavier Simonart <xavier.simonart@intel.com>
2020-05-29Added initial support for NDP (IPv6)Xavier Simonart1-3/+3
Following messages are now handled by PROX - router_solicitation - neighbour_solicitation - router_advertisement - neighbour_advertisement The following parameters are supported (through the PROX config file) - sub mode=ndp This will enable handling of router and neighbour solicitation and advertisement. - local ipv6=xxxx:xxxx:xxxxx:xxxx:xxxx:xxxx:xxxx:xxxx This will configure the local IPv6 address of the port. This parameter is optional. If not specified, the local IPv6 will be calculated from the EUI. - global ipv6=xxxx:xxxx:xxxxx:xxxx:xxxx:xxxx:xxxx:xxxx This will configure the global IPv6 address of the port. This parameter is optional. If not specified, the global IPv6 will be calculated from the EUI and the router prefix received from the router. - ipv6 router=yes This will cause the core to behave as an IPv6 router i.e. it will generate Router Advertisement messages This is only useful in back to back cases, when no real IPv6 router is present in the setup. - router prefix=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx The router prefix usedin the router advertisement The prefix will be used by the node to build an IPv6 global address in cases none were configured. "Unsollicited NA" parameter has been added within the core/task section. If set to yes (Unsollicited NA=yes), then an unsollicited neighbour Advertisement is sent at startup A same core/task cannot support both l3 and ndp mode. Those messages will be generated or handled when submode is set to "ndp": - neighbour sollicitation - neighbour advertisement - router sollicitation - router advertisement An example configuration is provided: config/ipv6.cfg in which port 0 / core 1 plays the role of the generator and port 1 / core 2 plays the role of the swap. Change-Id: Id0ab32d384448b4cf767fb4a1c486fc023f4f395 Signed-off-by: Xavier Simonart <xavier.simonart@intel.com>
2020-01-29Prepare for DPDK 19.08 supportXavier Simonart1-1/+1
This commit prepares PROX for supporting changes from DPDK 19.08 Mainly, the "sed" listed below were run. In addition, - some forward definition have been removed, - prox_compat.h has been updated - prox_compat.h has been included where necessary. Hence such a commit is rather easy to review and to reapply on other branches if necessary. sed -i 's/struct ether_hdr/prox_rte_ether_hdr/g' *.h sed -i 's/struct ether_hdr/prox_rte_ether_hdr/g' *.c sed -i 's/struct ether_addr/prox_rte_ether_addr/g' *.c sed -i 's/struct ether_addr/prox_rte_ether_addr/g' *.h sed -i 's/prox_rte_ether_addr_port/struct ether_addr_port/g' *.c sed -i 's/prox_rte_ether_addr_port/struct ether_addr_port/g' *.h sed -i 's/struct vlan_hdr/prox_rte_vlan_hdr/g' *.c sed -i 's/struct vlan_hdr/prox_rte_vlan_hdr/g' *.h sed -i 's/struct ipv4_hdr/prox_rte_ipv4_hdr/g' *.h sed -i 's/struct ipv4_hdr/prox_rte_ipv4_hdr/g' *.c sed -i 's/struct ipv6_hdr/prox_rte_ipv6_hdr/g' *.c sed -i 's/struct ipv6_hdr/prox_rte_ipv6_hdr/g' *.h sed -i 's/struct udp_hdr/prox_rte_udp_hdr/g' *.c sed -i 's/struct udp_hdr/prox_rte_udp_hdr/g' *.h sed -i 's/struct tcp_hdr/prox_rte_tcp_hdr/g' *.c sed -i 's/struct tcp_hdr/prox_rte_tcp_hdr/g' *.h sed -i 's/struct prox_rte_ether_addr_copy/ether_addr_copy/g' *.c sed -i 's/struct prox_rte_ether_addr_copy/ether_addr_copy/g' *.h sed -i 's/struct prox_rte_ether_addr_copy/prox_rte_ether_addr_copy/g' *.c sed -i 's/struct prox_rte_ether_addr_copy/ether_addr_copy/g' *.h sed -i 's/prox_rte_ether_addr_copy/ether_addr_copy/g' *.h sed -i 's/prox_rte_ether_addr_copy/ether_addr_copy/g' *.c sed -i 's/ether_addr_copy/prox_rte_ether_addr_copy/g' *.c sed -i 's/ether_addr_copy/prox_rte_ether_addr_copy/g' *.h sed -i 's/prox_rte_ether_hdr_arp/struct ether_hdr_arp/g' *.h sed -i 's/prox_rte_ether_hdr_arp/struct ether_hdr_arp/g' *.c sed -i 's/struct vxlan_gpe_hdr/prox_rte_vxlan_gpe_hdr/g' *.h sed -i 's/struct vxlan_gpe_hdr/prox_rte_vxlan_gpe_hdr/g' *.c sed -i 's/eth_random_addr/prox_rte_eth_random_addr/g' *.c sed -i 's/eth_random_addr/prox_rte_eth_random_addr/g' *.h sed -i 's/ETHER_CRC_LEN/PROX_RTE_ETHER_CRC_LEN/g' *.c sed -i 's/ETHER_CRC_LEN/PROX_RTE_ETHER_CRC_LEN/g' *.h sed -i 's/ETHER_HDR_LEN/PROX_RTE_ETHER_HDR_LEN/g' *.c sed -i 's/ETHER_HDR_LEN/PROX_RTE_ETHER_HDR_LEN/g' *.h sed -i 's/ETHER_MAX_LEN/PROX_RTE_ETHER_MAX_LEN/g' *.c sed -i 's/ETHER_MAX_LEN/PROX_RTE_ETHER_MAX_LEN/g' *.h sed -i 's/ETHER_MIN_LEN/PROX_RTE_ETHER_MIN_LEN/g' *.c sed -i 's/ETHER_MIN_LEN/PROX_RTE_ETHER_MIN_LEN/g' *.h sed -i 's/TCP_SYN_FLAG/PROX_RTE_TCP_SYN_FLAG/g' *.c sed -i 's/TCP_RST_FLAG/PROX_RTE_TCP_RST_FLAG/g' *.c sed -i 's/TCP_FIN_FLAG/PROX_RTE_TCP_FIN_FLAG/g' *.c sed -i 's/TCP_ACK_FLAG/PROX_RTE_TCP_ACK_FLAG/g' *.c Change-Id: I4dfe8be68e618c94dcaae28754579fbeb571bb00 Signed-off-by: Xavier Simonart <xavier.simonart@intel.com>
2019-10-21Fix two strncpy issues introduced by fb0c44a8Xavier Simonart1-1/+1
Change-Id: Ic452b22dc2522a1b49e3091cb25f2784bc505b41 Signed-off-by: Xavier Simonart <xavier.simonart@intel.com>
2019-10-08Fix compatibility with GCC 6 and earlierXavier Simonart1-2/+2
fb0c44a fixed compilation on GCC 8 by using: 1) #pragma GCC diagnostic ignored "-Wstringop-truncation" 2) __attribute__ ((fallthrough)); However, -Wstringop-truncation has only been introduced in GCC 8 and __attribute__ ((fallthrough)) has only been introduced in GCC 7. Hence they caused Warnings/Errors on earlier versions. Comments about fallthough (see https://developers.redhat.com/blog/2017/03/10/wimplicit-fallthrough-in-gcc-7/) can be used on GCC 8 to prevent fall through warnings Signed-off-by: Xavier Simonart <xavier.simonart@intel.com> Change-Id: I6f22e023191bbf22d8b01f1812061795a6494134
2019-10-08Support for recent GCC compilerXavier Simonart1-9/+12
This is required for instance on gcc (GCC) 8.2.1 20180905 Signed-off-by: Xavier Simonart <xavier.simonart@intel.com> Change-Id: Id86de5d39d77c5cbf168cc51434f436f84376a4c
2019-06-14Support multiple tasks in "dp core stats" commandXavier Simonart1-1/+1
The "dp core stats" command supported, as other commands, multiple cores but not multiple tasks. It now supports both (e.g. dp core stats 1-2 0-1). This is necessary so that users can collect all statistics from PROX in one command line. It will return similar information on the screen or through the socket: - if the syntax is wrong (e.g. missing task, too many cores or tasks, ...) => an error message is printed on the screen, and the single error line "error: invalid syntax" is returned through the socket - if the syntax is correct => one line is printed or returned for each core/task pair => if the core/task pair is invalid, the line reports an error => otherwise, the line provides dataplane statistics for the core/task pair, with the core_id and task_id added, either at the end of the line returned through the socket, or at the beginning of the line printed on the screen. This means a change in behaviour when using the socket: before, when an error happened (e.g. bad task), then nothing was returned which made it difficult for the script to catch the syntax error. Similar behaviour could/should be implemented for other commands. However, care must be taken as some scripts like NSB might count the number of lines within the output, or the number of items within the line. This should not be an issue for dp core stats as NSB does not use it, and other PROX scripts do not count the number of items and will be adjusted to count the number of lines. Change-Id: I582a671ae3d2f6493f791e80fc28e70f8e3a38d1 Signed-off-by: Xavier Simonart <xavier.simonart@intel.com> Signed-off-by: Patrice Buriez <patrice.buriez@intel.com>
2018-03-30Support additional MAC format in config fileIgor Shaula1-0/+2
Add support for space-divided bytes in MAC string. Support the same format as in "pkt inline". Change-Id: I7f2136c4424c45ce4abad4082470c9c9b1b3ab05 Signed-off-by: Igor Shaula <igor.shaula@intel.com>
2018-02-15Add support for comments in configuration variablesXavier Simonart1-2/+2
This feature will enable the possibility to have many cores configured in a prox config file, and enable/disable them through variables. For instance, a [core $var1] section in a config file will result in [core 1] if $var1 = 1; the whole section and section content will be ignored if $var1=# Before this implementation, [#core 1] or [core #] was already treated as a commented out section (the whole section was commented). But there was no way to define a variable $var = # to comment a section through a variable. Note that in today's implementation any non numerical (except s, h, t, -) characteter in the [core] section header (and not only #) will cause the section to be ignored. It would probably be better to consider # (as maybe N/A and none) as comments, and everything else as error. This is however not supported by the change request. Change-Id: Id4e2b27a1f9b6d595e0b442dcd971ad44a502031 Signed-off-by: Xavier Simonart <xavier.simonart@intel.com>
2017-07-14Adding PROX(Packet pROcessing eXecution engine) VNF to sampleVNFDeepak S1-0/+1420
JIRA: SAMPLEVNF-55 PROX is a DPDK-based application implementing Telco use-cases such as a simplified BRAS/BNG, light-weight AFTR... It also allows configuring finer grained network functions like QoS, Routing, load-balancing... (We are moving PROX version v039 to sampleVNF https://01.org/intel-data-plane-performance-demonstrators/prox-overview) Change-Id: Ia3cb02cf0e49ac5596e922c197ff7e010293d033 Signed-off-by: Deepak S <deepak.s@linux.intel.com>