| Age | Commit message (Collapse) | Author | Files | Lines |
|---|
|
UDP and IP packet length and source UDP port and destination UDP port
were wrongly set for IPv6 packets.
In the *.test files, there is now an optional boolean field (ipv6) in
the [TestParameters] section. When set to true, the generator will use
the IPv6 packet layout to place the right values at the proper offset
in the packet. If not present or set to false, the IPv4 layout will be
used. Note also that packet size needs to be at least 84 bytes for IPV6
traffic since we need space for latency and other information in each
packet.
Packet loss ratio is now printed as a percentage of the total packets
sent.
Change-Id: I2136e87f3032348ae95b69052be7da8461c6303c
Signed-off-by: Luc Provoost <luc.provoost@intel.com>
|
|
Using vfio in stead of igb_uio. DPDK 2020.5 is NOT compiling the igb_uio
driver by default any more.
For the l3 mode, we are now using the new PROX vdev feature. This is
achieved by adding the vdev parameter in the port section of the PROX
config files. One of the advantages is that we can now ping a port
managed by PROX: the requests will be forwarded by PROX to the LINUX
stack, who will reply to the ping. A tap device is being created by PROX
to support this feature.
Installing old version of nasm since latest causes some issues.
If not pushgateway is being used, it should be commented out in the
config_file.
vfio is now loaded by specifying the module in /etc/modules-load.d
There is also an after_boot.sh script that will be run by
check_prox_system_setup.sh, which can be used for further configuration
of the instance after boot.
There is now also a file created /opt/rapid/system_ready_for_rapid by
the check_prox_system_setup.sh script. This file is created once all
configuration is done. The runrapid.py script will wait till this file
is created before executing any tests.
Change-Id: Ic5c41af82642066af42134c3323297f5a06f6f72
Signed-off-by: Luc Provoost <luc.provoost@intel.com>
|
|
Since runrapid.py is now supporting more than 1 dataplane interface, we
need to use a port index in the rapid.env file for the dataplane ports.
In k8sdeployment.py, we only support 1 dataplane port, but we are
writing dp_ip1 and dp_mac1 in the environment file. The copyright dates
are also updated. Some references to VM have also been changed to instance.
Change-Id: Ie1d036c13ef5d6f0aa1f35aa068a9760a1cfc2a9
Signed-off-by: Luc Provoost <luc.provoost@intel.com>
|
|
IPV6 test has been added. The generator will now generate IPV6 packets
using NDP to resolve MAC addresses. The hex IP addresses in the inline
definition of the packets in the cfg files is now calculated by a lua
function called in parameters.lua. The hard-coded path /home/centos has
been replaced by ~. An error in the speed calculations has been fixed.
See the RapidTest class for details. The actual number of generated
flows is now reported. If the requested number of flows is not a power
of 2, the lowest power of 2 that is larger than the requested number of
flows will be used and reported.
Change-Id: I36b8d345b4a03c2cf358c19ec353ca8ad2831293
Signed-off-by: Luc Provoost <luc.provoost@intel.com>
|
Luc Provoost