1 files changed, 0 insertions, 247 deletions

diff --git a/qemu/roms/u-boot/board/freescale/mpc8572ds/mpc8572ds.c b/qemu/roms/u-boot/board/freescale/mpc8572ds/mpc8572ds.c
deleted file mode 100644
index 56863222c..000000000
--- a/qemu/roms/u-boot/board/freescale/mpc8572ds/mpc8572ds.c
+++ /dev/null
@@ -1,247 +0,0 @@
-/*
- * Copyright 2007-2011 Freescale Semiconductor, Inc.
- *
- * SPDX-License-Identifier:	GPL-2.0+
- */
-
-#include <common.h>
-#include <command.h>
-#include <pci.h>
-#include <asm/processor.h>
-#include <asm/mmu.h>
-#include <asm/cache.h>
-#include <asm/immap_85xx.h>
-#include <asm/fsl_pci.h>
-#include <fsl_ddr_sdram.h>
-#include <asm/io.h>
-#include <asm/fsl_serdes.h>
-#include <miiphy.h>
-#include <libfdt.h>
-#include <fdt_support.h>
-#include <tsec.h>
-#include <fsl_mdio.h>
-#include <netdev.h>
-
-#include "../common/sgmii_riser.h"
-
-int checkboard (void)
-{
-	u8 vboot;
-	u8 *pixis_base = (u8 *)PIXIS_BASE;
-
-	printf("Board: MPC8572DS Sys ID: 0x%02x, "
-		"Sys Ver: 0x%02x, FPGA Ver: 0x%02x, ",
-		in_8(pixis_base + PIXIS_ID), in_8(pixis_base + PIXIS_VER),
-		in_8(pixis_base + PIXIS_PVER));
-
-	vboot = in_8(pixis_base + PIXIS_VBOOT);
-	switch ((vboot & PIXIS_VBOOT_LBMAP) >> 6) {
-		case PIXIS_VBOOT_LBMAP_NOR0:
-			puts ("vBank: 0\n");
-			break;
-		case PIXIS_VBOOT_LBMAP_PJET:
-			puts ("Promjet\n");
-			break;
-		case PIXIS_VBOOT_LBMAP_NAND:
-			puts ("NAND\n");
-			break;
-		case PIXIS_VBOOT_LBMAP_NOR1:
-			puts ("vBank: 1\n");
-			break;
-	}
-
-	return 0;
-}
-
-
-#if !defined(CONFIG_SPD_EEPROM)
-/*
- * Fixed sdram init -- doesn't use serial presence detect.
- */
-
-phys_size_t fixed_sdram (void)
-{
-	volatile immap_t *immap = (immap_t *)CONFIG_SYS_IMMR;
-	struct ccsr_ddr __iomem *ddr = &immap->im_ddr;
-	uint d_init;
-
-	ddr->cs0_bnds = CONFIG_SYS_DDR_CS0_BNDS;
-	ddr->cs0_config = CONFIG_SYS_DDR_CS0_CONFIG;
-
-	ddr->timing_cfg_3 = CONFIG_SYS_DDR_TIMING_3;
-	ddr->timing_cfg_0 = CONFIG_SYS_DDR_TIMING_0;
-	ddr->timing_cfg_1 = CONFIG_SYS_DDR_TIMING_1;
-	ddr->timing_cfg_2 = CONFIG_SYS_DDR_TIMING_2;
-	ddr->sdram_mode = CONFIG_SYS_DDR_MODE_1;
-	ddr->sdram_mode_2 = CONFIG_SYS_DDR_MODE_2;
-	ddr->sdram_interval = CONFIG_SYS_DDR_INTERVAL;
-	ddr->sdram_data_init = CONFIG_SYS_DDR_DATA_INIT;
-	ddr->sdram_clk_cntl = CONFIG_SYS_DDR_CLK_CTRL;
-	ddr->sdram_cfg_2 = CONFIG_SYS_DDR_CONTROL2;
-
-#if defined (CONFIG_DDR_ECC)
-	ddr->err_int_en = CONFIG_SYS_DDR_ERR_INT_EN;
-	ddr->err_disable = CONFIG_SYS_DDR_ERR_DIS;
-	ddr->err_sbe = CONFIG_SYS_DDR_SBE;
-#endif
-	asm("sync;isync");
-
-	udelay(500);
-
-	ddr->sdram_cfg = CONFIG_SYS_DDR_CONTROL;
-
-#if defined(CONFIG_ECC_INIT_VIA_DDRCONTROLLER)
-	d_init = 1;
-	debug("DDR - 1st controller: memory initializing\n");
-	/*
-	 * Poll until memory is initialized.
-	 * 512 Meg at 400 might hit this 200 times or so.
-	 */
-	while ((ddr->sdram_cfg_2 & (d_init << 4)) != 0) {
-		udelay(1000);
-	}
-	debug("DDR: memory initialized\n\n");
-	asm("sync; isync");
-	udelay(500);
-#endif
-
-	return 512 * 1024 * 1024;
-}
-
-#endif
-
-#ifdef CONFIG_PCI
-void pci_init_board(void)
-{
-	struct pci_controller *hose;
-
-	fsl_pcie_init_board(0);
-
-	hose = find_hose_by_cfg_addr((void *)(CONFIG_SYS_PCIE3_ADDR));
-
-	if (hose) {
-		u32 temp32;
-		u8 uli_busno = hose->first_busno + 2;
-
-		/*
-		 * Activate ULI1575 legacy chip by performing a fake
-		 * memory access.  Needed to make ULI RTC work.
-		 * Device 1d has the first on-board memory BAR.
-		 */
-		pci_hose_read_config_dword(hose, PCI_BDF(uli_busno, 0x1d, 0),
-				PCI_BASE_ADDRESS_1, &temp32);
-
-		if (temp32 >= CONFIG_SYS_PCIE3_MEM_BUS) {
-			void *p = pci_mem_to_virt(PCI_BDF(uli_busno, 0x1d, 0),
-					temp32, 4, 0);
-			debug(" uli1572 read to %p\n", p);
-			in_be32(p);
-		}
-	}
-}
-#endif
-
-int board_early_init_r(void)
-{
-	const unsigned int flashbase = CONFIG_SYS_FLASH_BASE;
-	const u8 flash_esel = find_tlb_idx((void *)flashbase, 1);
-
-	/*
-	 * Remap Boot flash + PROMJET region to caching-inhibited
-	 * so that flash can be erased properly.
-	 */
-
-	/* Flush d-cache and invalidate i-cache of any FLASH data */
-	flush_dcache();
-	invalidate_icache();
-
-	/* invalidate existing TLB entry for flash + promjet */
-	disable_tlb(flash_esel);
-
-	set_tlb(1, flashbase, CONFIG_SYS_FLASH_BASE_PHYS,	/* tlb, epn, rpn */
-			MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G,	/* perms, wimge */
-			0, flash_esel, BOOKE_PAGESZ_256M, 1);	/* ts, esel, tsize, iprot */
-
-	return 0;
-}
-
-#ifdef CONFIG_TSEC_ENET
-int board_eth_init(bd_t *bis)
-{
-	struct fsl_pq_mdio_info mdio_info;
-	struct tsec_info_struct tsec_info[4];
-	int num = 0;
-
-#ifdef CONFIG_TSEC1
-	SET_STD_TSEC_INFO(tsec_info[num], 1);
-	if (is_serdes_configured(SGMII_TSEC1)) {
-		puts("eTSEC1 is in sgmii mode.\n");
-		tsec_info[num].flags |= TSEC_SGMII;
-	}
-	num++;
-#endif
-#ifdef CONFIG_TSEC2
-	SET_STD_TSEC_INFO(tsec_info[num], 2);
-	if (is_serdes_configured(SGMII_TSEC2)) {
-		puts("eTSEC2 is in sgmii mode.\n");
-		tsec_info[num].flags |= TSEC_SGMII;
-	}
-	num++;
-#endif
-#ifdef CONFIG_TSEC3
-	SET_STD_TSEC_INFO(tsec_info[num], 3);
-	if (is_serdes_configured(SGMII_TSEC3)) {
-		puts("eTSEC3 is in sgmii mode.\n");
-		tsec_info[num].flags |= TSEC_SGMII;
-	}
-	num++;
-#endif
-#ifdef CONFIG_TSEC4
-	SET_STD_TSEC_INFO(tsec_info[num], 4);
-	if (is_serdes_configured(SGMII_TSEC4)) {
-		puts("eTSEC4 is in sgmii mode.\n");
-		tsec_info[num].flags |= TSEC_SGMII;
-	}
-	num++;
-#endif
-
-	if (!num) {
-		printf("No TSECs initialized\n");
-
-		return 0;
-	}
-
-#ifdef CONFIG_FSL_SGMII_RISER
-	fsl_sgmii_riser_init(tsec_info, num);
-#endif
-
-	mdio_info.regs = (struct tsec_mii_mng *)CONFIG_SYS_MDIO_BASE_ADDR;
-	mdio_info.name = DEFAULT_MII_NAME;
-	fsl_pq_mdio_init(bis, &mdio_info);
-
-	tsec_eth_init(bis, tsec_info, num);
-
-	return pci_eth_init(bis);
-}
-#endif
-
-#if defined(CONFIG_OF_BOARD_SETUP)
-void ft_board_setup(void *blob, bd_t *bd)
-{
-	phys_addr_t base;
-	phys_size_t size;
-
-	ft_cpu_setup(blob, bd);
-
-	base = getenv_bootm_low();
-	size = getenv_bootm_size();
-
-	fdt_fixup_memory(blob, (u64)base, (u64)size);
-
-	FT_FSL_PCI_SETUP;
-
-#ifdef CONFIG_FSL_SGMII_RISER
-	fsl_sgmii_riser_fdt_fixup(blob);
-#endif
-}
-#endif