blob: 605bb934facac48bb2a97a77e6f62e1eb738abc5 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
|
############################################################################################################################
# Date: <22/08/2016> Version: <1.1> #
############################################################################################################################
Feature: Attach Procedure With P-CSCF Address Request Indication in PCO
@attach-procedure @TS_24_301 @24_301_5_5 @24_301_5_5_1_2_2 @TS_24_368 @24_368_4 @24_368-5_4 @Series-0000
@TS_36_523_9_2_1_1_3 @Attach_Procedure_P-CSCF_Address_Request @PCO
Scenario: Attach Procedure indicating a request for P-CSCF address in the protocol configuration options
Given all configured endpoints for SSH are connected successfully
Given the steps below will be executed at the end
When I stop S1AP simulator on node ABOT
When I run the SSH command "sudo service mme_gw restart" on node MME
Given the execution is paused for {abotprop.WAIT_10_SEC} seconds
Then the ending steps are complete
# Set ABOT configuration
Given that I setup S1AP Simulator with default parameters specified in {abotprop.ABOT.EPC.Defaults} on node ABOT
Given that I setup S1AP Simulator with USIM parameter "ABOT.UE.USIM.AttachWithImsi=true" on node ABOT
Given that I setup S1AP Simulator with UE parameter "ABOT.UE.CONFIG.PCO.IPV6_P_CSCF_ADDR_REQ=true" on node ABOT
# Execute ABOT S1AP Simulator
When I run S1AP simulator on node ABOT with 1 UE
# Wait for execution to complete before checking results
Given the execution is paused for {abotprop.WAIT_10_SEC} seconds
# Validate Test Case Execution at Simulator
Then I receive S1AP response on node ABOT and verify the presence of all the following values:
| responseResult | existence |
| Send Attach Request message with IMSI | {string:nocase:present} |
| Send PDN Connectivity Request message with P-CSCF Address Request | {string:nocase:present} |
| Received Authentication Request message | {string:nocase:present} |
| Send Authentication Response message | {string:nocase:present} |
| Received Authentication Request message | {string:nocase:present} |
| Send Authentication Response message | {string:nocase:present} |
| Received Security Mode Command message | {string:nocase:present} |
| Send Security Mode Complete message | {string:nocase:present} |
| Received Attach Accept message | {string:nocase:present} |
| Received Activate Default EPS Bearer Context Request message with PCO contain Protocol ID 0001 | {string:nocase:present} |
|
