diff options
Diffstat (limited to 'docs')
| -rw-r--r-- | docs/results/fuel-os-nosdn-nofeature-ha.rst | 109 |
1 files changed, 101 insertions, 8 deletions
diff --git a/docs/results/fuel-os-nosdn-nofeature-ha.rst b/docs/results/fuel-os-nosdn-nofeature-ha.rst index 23e3ac3ab..eb8b14741 100644 --- a/docs/results/fuel-os-nosdn-nofeature-ha.rst +++ b/docs/results/fuel-os-nosdn-nofeature-ha.rst @@ -14,25 +14,118 @@ Test Results for fuel-os-nosdn-nofeature-ha Details ======= -.. after this doc is filled, remove all comments and include the scenario in -.. results.rst by removing the comment on the file name. - +.. _Grafana: http://130.211.154.108/grafana/dashboard/db/yardstick-main +.. _POD2: https://wiki.opnfv.org/pharos?&#community_test_labs Overview of test results ------------------------ -.. general on metrics collected, number of iterations +See Grafana_ for viewing test result metrics for each respective test case. It +is possible to chose which specific scenarios to look at, and then to zoom in +on the details of each run test scenario as well. + +All of the test case results below are based on 5 consecutive scenario test +runs, each run on the Ericsson POD2_ between February 13 and 18 in 2016. The +best would be to have more runs to draw better conclusions from, but these are +the only runs available at the time of OPNFV R2 release. + +TC002 +----- +The round-trip-time (RTT) between 2 VMs on different blades is measured using +ping. The measurements are on average varying between 0.5 and 1.1 ms +with a first 2 - 2.5 ms RTT spike in the beginning of each run (This could be +because of normal ARP handling). The 2 last runs are very similar in their +results. But, to be able to draw any further conclusions more runs should be +made. There is one measurement taken on February 16 that does not have the +first RTT spike, and less variations to the RTT. The reason for this is +unknown. There is a discussion on another test measurement made Feb. 16 in +TC037_. +SLA set to 10 ms. The SLA value is used as a reference, it has not +been defined by OPNFV. + +TC005 +----- +The IO read bandwidth look similar between different test runs, with an +average at approx. 160-170 MB/s. Within each run the results vary much, +minimum 2 MB/s and maximum 630 MB/s on the totality. Most runs have a +minimum of 3 MB/s (one run at 2 MB/s). The maximum BW varies much more in +absolute numbers, between 566 and 630 MB/s. +SLA set to 400 MB/s. The SLA value is used as a reference, it has not been +defined by OPNFV. + +TC010 +----- +The measurements for memory latency are consistent among test runs and results +in approx. 1.2 ns. The variations between runs are similar, between +1.215 and 1.219 ns. One exception is February 16, where the varation is +greater, between 1.22 and 1.28 ns. SLA set to 30 ns. The SLA value is used as +a reference, it has not been defined by OPNFV. + +TC011 +----- +For this scenario no results are available to report on. Probable reason is +an integer/floating point issue regarding how InfluxDB is populated with +result data from the test runs. + +TC012 +----- +The average measurements for memory bandwidth are consistent among most of the +different test runs at 17.2 - 17.3 GB/s. The very first test run averages at +17.7 GB/s. Within each run the results vary, with a minimal BW of 15.4 +GB/s and maximum of 18.2 GB/s of the totality. +SLA set to 15 GB/s. The SLA value is used as a reference, it has not been +defined by OPNFV. + +TC014 +----- +The Unixbench processor single and parallel speed scores show similar results +at approx. 3200. The runs vary between scores 3160 and 3240. +No SLA set. + +TC037 +----- +The amount of packets per second (PPS) and round trip times (RTT) between 2 VMs +on different blades are measured when increasing the amount of UDP flows sent +between the VMs using pktgen as packet generator tool. + +Round trip times and packet throughput between VMs are typically affected by +the amount of flows set up and result in higher RTT and less PPS +throughput. + +When running with less than 10000 flows the results are flat and consistent. +RTT is then approx. 30 ms and the number of PPS remains flat at approx. +250000 PPS. Beyond approx. 10000 flows and up to 1000000 (one million) there +is an even drop in RTT and PPS performance, eventually ending up at approx. +150-250 ms and 40000 PPS respectively. + +There is one measurement made February 16 that has slightly worse results +compared to the other 4 measurements. The reason for this is unknown. For +instance anyone being logged onto the POD can be of relevance for such a +disturbance. Detailed test results --------------------- +The scenario was run on Ericsson POD2_ with: +Fuel 8.0 +OpenStack Liberty +OVS 2.3.1 -.. info on lab, installer, scenario +No SDN controller installed Rationale for decisions ----------------------- -.. result analysis, pass/fail +Pass + +Tests were successfully executed and metrics collects (apart from TC011_). +No SLA was verified. To be decided on in next release of OPNFV. Conclusions and recommendations ------------------------------- - -.. did the expected behavior occured? +The pktgen test configuration has a relatively large base effect on RTT in +TC037 compared to TC002, where there is no background load at all (30 ms +compared to 1 ms or less, which is more than a 3000 percentage different +in RTT results). The larger amounts of flows in TC037 generate worse +RTT results, in the magnitude of several hundreds of milliseconds. It would +be interesting to also make and compare all these measurements to completely +(optimized) bare metal machines running native Linux with all other relevant +tools available, e.g. lmbench, pktgen etc. |