diff options
Diffstat (limited to 'docs/results/os-onos-nofeature-ha.rst')
| -rw-r--r-- | docs/results/os-onos-nofeature-ha.rst | 257 |
1 files changed, 0 insertions, 257 deletions
diff --git a/docs/results/os-onos-nofeature-ha.rst b/docs/results/os-onos-nofeature-ha.rst deleted file mode 100644 index d8b3ace5f..000000000 --- a/docs/results/os-onos-nofeature-ha.rst +++ /dev/null @@ -1,257 +0,0 @@ -.. This work is licensed under a Creative Commons Attribution 4.0 International -.. License. -.. http://creativecommons.org/licenses/by/4.0 - - -====================================== -Test Results for os-onos-nofeature-ha -====================================== - -.. toctree:: - :maxdepth: 2 - - -Joid -===== - -.. _Grafana: http://testresults.opnfv.org/grafana/dashboard/db/yardstick-main -.. _POD6: https://wiki.opnfv.org/pharos?&#community_test_labs - -Overview of test results ------------------------- - -See Grafana_ for viewing test result metrics for each respective test case. It -is possible to chose which specific scenarios to look at, and then to zoom in -on the details of each run test scenario as well. - -All of the test case results below are based on 5 scenario test runs, each run -on the Intel POD6_ between September 13 and 16 in 2016. - -TC002 ------ -The round-trip-time (RTT) between 2 VMs on different blades is measured using -ping. Most test run measurements result on average between 1.50 and 1.68 ms. -Only one test run has reached greatest RTT spike of 2.62 ms, which has -the smallest RTT of 1.00 ms. The other four runs have no similar spike at all, -the minimum and average RTTs of which are approx. 1.06 ms and 1.32 ms. SLA set -to be 10 ms. The SLA value is used as a reference, it has not been defined by -OPNFV. - -TC005 ------ -The IO read bandwidth actually refers to the storage throughput, which is -measured by fio and the greatest IO read bandwidth of the four runs is 175.4 -MB/s. The IO read bandwidth of the four runs looks similar on different four -days, with an average between 58.1 and 62.0 MB/s, except one on Sep. 14, for -its maximum storage throughput is only 133.0 MB/s. One of the runs has a -minimum BW of 497 KM/s and other has a maximum BW of 177.4 MB/s. The SLA of read -bandwidth sets to be 400 MB/s, which is used as a reference, and it has not -been defined by OPNFV. - -The results of storage IOPS for the five runs look similar with each other. The -IO read times per second of the five test runs have an average value between -1.20 K/s and 1.61 K/s, and meanwhile, the minimum result is only 41 times per -second. - -TC010 ------ -The tool we use to measure memory read latency is lmbench, which is a series of -micro benchmarks intended to measure basic operating system and hardware system -metrics. The memory read latency of the five runs is between 1.146 ns and 1.172 -ns on average. The variations within each test run are quite different, some -vary from a large range and others have a small change. For example, the -largest change is on September 13, the memory read latency of which is ranging -from 1.152 ns to 1.221 ns. However, the results on September 14 change very -little. The SLA sets to be 30 ns. The SLA value is used as a reference, it has -not been defined by OPNFV. - -TC011 ------ -Iperf3 is a tool for evaluating the packet delay variation between 2 VMs on -different blades. The reported packet delay variations of the five test runs -differ from each other. In general, the packet delay of the first two runs look -similar, for they both stay stable within each run. And the mean packet delay of -of them are 0.07714 ms and 0.07982 ms respectively. Of the five runs, the third -has the worst result, because the packet delay reaches 0.08384 ms. The trend of -therest two runs look the same, for the average packet delay are 0.07808 ms and -0.07727 ms respectively. The SLA value sets to be 10 ms. The SLA value is used -as a reference, it has not been defined by OPNFV. - -TC012 ------ -Lmbench is also used to measure the memory read and write bandwidth, in which -we use bw_mem to obtain the results. Among the five test runs, the memory -bandwidth of last three test runs almost keep stable within each run, which is -11.64, 11.71 and 11.61 GB/s on average. However, the memory read and write -bandwidth on Sep. 13 has a large range, for it ranges from 6.68 GB/s to 11.73 -GB/s. Here SLA set to be 15 GB/s. The SLA value is used as a reference, it has -not been defined by OPNFV. - -TC014 ------ -The Unixbench is used to evaluate the IaaS processing speed with regards to -score of single cpu running and parallel running. It can be seen from the -dashboard that the processing test results vary from scores 3208 to 3314, and -there is only one result one date. No SLA set. - -TC037 ------ -The amount of packets per second (PPS) and round trip times (RTT) between 2 VMs -on different blades are measured when increasing the amount of UDP flows sent -between the VMs using pktgen as packet generator tool. - -Round trip times and packet throughput between VMs can typically be affected by -the amount of flows set up and result in higher RTT and less PPS throughput. - -The mean packet throughput of the five test runs is between 259.6 kpps and -318.4 kpps, of which the result of the second run is the highest. The RTT -results of all the test runs keep flat at approx. 20 ms. It is obvious that the -PPS results are not as consistent as the RTT results. - -The No. flows of the five test runs are 240 k on average and the PPS results -look a little waved since the largest packet throughput is 398.9 kpps and the -minimum throughput is 250.6 kpps respectively. - -There are no errors of packets received in the five runs, but there are still -lost packets in all the test runs. The RTT values obtained by ping of the five -runs have the similar average vaue, that is between 17 ms and 22 ms, of which -the worest RTT is 53 ms on Sep. 14th. - -CPU load is measured by mpstat, and CPU load of the four test runs seem a -little similar, since the minimum value and the peak of CPU load is between 0 -percent and 10 percent respectively. And the best result is obtained on Sep. -13rd, with an CPU load of 10 percent. - -TC069 ------ -With the block size changing from 1 kb to 512 kb, the memory write bandwidth -tends to become larger first and then smaller within every run test, which -rangs from 21.6 GB/s to 26.8 GB/s and then to 18.4 GB/s on average. Since the -test id is one, it is that only the INT memory write bandwidth is tested. On -the whole, when the block size is 8 kb and 16 kb, the memory write bandwidth -look similar with a minimal BW of 23.0 GB/s and peak value of 28.6 GB/s. And -then with the block size becoming larger, the memory write bandwidth tends to -decrease. SLA sets to be 7 GB/s. The SLA value is used as a a reference, it has -not been defined by OPNFV. - -TC070 ------ -The amount of packets per second (PPS) and round trip times (RTT) between 2 VMs -on different blades are measured when increasing the amount of UDP flows sent -between the VMs using pktgen as packet generator tool. - -Round trip times and packet throughput between VMs can typically be affected by -the amount of flows set up and result in higher RTT and less PPS throughput. - -The network latency is measured by ping, and the results of the five test runs -look similar with each other, and within these test runs, the maximum RTT can -reach 53 ms and the average RTT is usually approx. 18 ms. The network latency -tested on Sep. 14 shows that it has a peak latency of 53 ms. But on the whole, -the average RTTs of the five runs keep flat and the network latency is -relatively short. - -Memory utilization is measured by free, which can display amount of free and -used memory in the system. The largest amount of used memory is 272 MiB on Sep -14. In general, the mean used memory of the five test runs have the similar -trend and the minimum memory used size is approx. 150 MiB, and the average -used memory size is about 250 MiB. On the other hand, for the mean free memory, -the five test runs have the similar trend, whose mean free memory change from -218 MiB to 342 MiB, with an average value of approx. 38 MiB. - -Packet throughput and packet loss can be measured by pktgen, which is a tool -in the network for generating traffic loads for network experiments. The mean -packet throughput of the five test runs seem quite different, ranging from -285.29 kpps to 297.76 kpps. The average number of flows in these tests is -240000, and each run has a minimum number of flows of 2 and a maximum number -of flows of 1.001 Mil. At the same time, the corresponding packet throughput -differ between 250.6k and 398.9k with an average packet throughput between -277.2 K and 318.4 K. In summary, the PPS results seem consistent. Within each -test run of the five runs, when number of flows becomes larger, the packet -throughput seems not larger at the same time. - -TC071 ------ -The amount of packets per second (PPS) and round trip times (RTT) between 2 VMs -on different blades are measured when increasing the amount of UDP flows sent -between the VMs using pktgen as packet generator tool. - -Round trip times and packet throughput between VMs can typically be affected by -the amount of flows set up and result in higher RTT and less PPS throughput. - -The network latency is measured by ping, and the results of the five test runs -look similar with each other. Within each test run, the maximum RTT is only 49 -ms and the average RTT is usually approx. 20 ms. On the whole, the average -RTTs of the five runs keep stable and the network latency is relatively short. - -Cache utilization is measured by cachestat, which can display size of cache and -buffer in the system. Cache utilization statistics are collected during UDP -flows sent between the VMs using pktgen as packet generator tool.The largest -cache size is 215 MiB in the four runs, and the smallest cache size is 95 MiB. -On the whole, the average cache size of the five runs change a little and is -about 200 MiB, except the one on Sep. 14th, the mean cache size is very small, -which keeps 102 MiB. Meanwhile, the tread of the buffer size keep flat, since -they have a minimum value of 7 MiB and a maximum value of 8 MiB, with an -average value of about 7.8 MiB. - -Packet throughput can be measured by pktgen, which is a tool in the network for -generating traffic loads for network experiments. The mean packet throughput of -the four test runs seem quite different, ranging from 285.29 kpps to 297.76 -kpps. The average number of flows in these tests is 239.7k, and each run has a -minimum number of flows of 2 and a maximum number of flows of 1.001 Mil. At the -same time, the corresponding packet throughput differ between 227.3k and 398.9k -with an average packet throughput between 277.2k and 318.4k. Within each test -run of the five runs, when number of flows becomes larger, the packet -throughput seems not larger in the meantime. - -TC072 ------ -The amount of packets per second (PPS) and round trip times (RTT) between 2 VMs -on different blades are measured when increasing the amount of UDP flows sent -between the VMs using pktgen as packet generator tool. - -Round trip times and packet throughput between VMs can typically be affected by -the amount of flows set up and result in higher RTT and less PPS throughput. - -The RTT results are similar throughout the different test dates and runs - between 0 ms and 49 ms with an average leatency of less than 22 ms. The PPS -results are not as consistent as the RTT results, for the mean packet -throughput of the five runs differ from 250.6 kpps to 398.9 kpps. - -Network utilization is measured by sar, that is system activity reporter, which -can display the average statistics for the time since the system was started. -Network utilization statistics are collected during UDP flows sent between the -VMs using pktgen as packet generator tool. The largest total number of packets -transmitted per second look similar for four test runs, whose values change a -lot from 10 pps to 399 kpps, except the one on Sep. 14th, whose total number -of transmitted per second keep stable, that is 10 pps. Similarly, the total -number of packets received per second look the same for four runs, except the -one on Sep. 14th, whose value is only 10 pps. - -In some test runs when running with less than approx. 90000 flows the PPS -throughput is normally flatter compared to when running with more flows, after -which the PPS throughput decreases. For the other test runs there is however no -significant change to the PPS throughput when the number of flows are -increased. In some test runs the PPS is also greater with 250000 flows -compared to other test runs where the PPS result is less with only 2 flows. - -There are lost packets reported in most of the test runs. There is no observed -correlation between the amount of flows and the amount of lost packets. -The lost amount of packets normally differs a lot per test run. - -Detailed test results ---------------------- -The scenario was run on Intel POD6_ with: -Joid -OpenStack Mitaka -Onos Goldeneye -OpenVirtualSwitch 2.5.90 -OpenDayLight Beryllium - -Rationale for decisions ------------------------ -Pass - -Conclusions and recommendations -------------------------------- -Tests were successfully executed and metrics collected. -No SLA was verified. To be decided on in next release of OPNFV. |