diff options
Diffstat (limited to 'framework/src/suricata/doc/Mac_OS_X_106x.txt')
| -rw-r--r-- | framework/src/suricata/doc/Mac_OS_X_106x.txt | 72 |
1 files changed, 0 insertions, 72 deletions
diff --git a/framework/src/suricata/doc/Mac_OS_X_106x.txt b/framework/src/suricata/doc/Mac_OS_X_106x.txt deleted file mode 100644 index 0f76a047..00000000 --- a/framework/src/suricata/doc/Mac_OS_X_106x.txt +++ /dev/null @@ -1,72 +0,0 @@ -Autogenerated on 2012-11-29 -from - https://redmine.openinfosecfoundation.org/projects/suricata/wiki/Mac_OS_X_106x - - -Mac OS X (10.6.x) - - -Pre-installation requirements - -These instructions have been tested with Mac OS X (10.6.1). To begin, you will -need an essential development environment much like gcc/make. You can download -Xcode from http://developer.apple.com/technology/xcode.html. -MacPorts is required for you to fetch the depends, so you will also need to -install MacPorts, if you have not already done so. The online installation -guide is located at http://guide.macports.org/#installing. -Before you can build Suricata for your system, you must run the following -command to ensure that you have everything you need for the installation. - - port install autoconf automake gcc44 make libnet11 libpcap pcre \ - libyaml libtool - export AC_PROG_LIBTOOL=$( which libtool ) - -Depending on the current status of your system, it may take a while to complete -this process. - -HTP - -HTP is bundled with Suricata and installed automatically. If you need to -install HTP manually for other reasons, instructions can be found at HTP -library_installation. - -IPS - -If you would like to have IPS capabilities with IPFW, then you should run -configure like this: - - ./configure --enable-ipfw --prefix=/usr --sysconfdir=/etc --localstatedir=/ - var - -and execute the rest of the commands the same as above. - -Suricata - -To download and build Suricata, enter the following: - - wget http://www.openinfosecfoundation.org/download/suricata-1.3.3.tar.gz - tar -xvzf suricata-1.3.3.tar.gz - cd suricata-1.3.3 - -You will also need to have an ipfw rule set for the engine to see the packets -from ipfw. For example: - - ipfw add 100 divert 8000 ip from any to any - -The 8000 above should be the same number you pass on the command line of -suricata with the option -d, that is, -d 8000: - - suricata -c config_file.yaml -d 8000 - -You will need a Suricata rule set with IPS options (drop, reject, etc). For -this, please refer to the Emerging Threats rule sets. -If you are building from Git sources, enter the following: - - bash autogen.sh - -If you are not building from Git sources, enter the following: - - ./configure --prefix=/usr --sysconfdir=/etc --localstatedir=/var - make - sudo make install - -Please continue with the Basic_Setup. |