blob: 97bbe996f790dafd4374ce59c00090b72b8351f4 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
|
/*
* (C) Copyright 2010
* Marvell Semiconductor <www.marvell.com>
* Written-by: Prafulla Wadaskar <prafulla@marvell.com>,
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#include <asm/io.h>
#include <mvmfp.h>
#include <asm/arch/mfp.h>
/*
* mfp_config
*
* On most of Marvell SoCs (ex. ARMADA100) there is Multi-Funtion-Pin
* configuration registers to configure each GPIO/Function pin on the
* SoC.
*
* This function reads the array of values for
* MFPR_X registers and programms them into respective
* Multi-Function Pin registers.
* It supports - Alternate Function Selection programming.
*
* Whereas,
* The Configureation value is constructed using MFP()
* array consists of 32bit values as defined in MFP(xx,xx..) macro
*/
void mfp_config(u32 *mfp_cfgs)
{
u32 *p_mfpr = NULL;
u32 cfg_val, val;
do {
cfg_val = *mfp_cfgs++;
/* exit if End of configuration table detected */
if (cfg_val == MFP_EOC)
break;
p_mfpr = (u32 *)(MV_MFPR_BASE
+ MFP_REG_GET_OFFSET(cfg_val));
/* Write a mfg register as per configuration */
val = 0;
if (cfg_val & MFP_AF_FLAG)
/* Abstract and program Afternate-Func Selection */
val |= cfg_val & MFP_AF_MASK;
if (cfg_val & MFP_EDGE_FLAG)
/* Abstract and program Edge configuration */
val |= cfg_val & MFP_LPM_EDGE_MASK;
if (cfg_val & MFP_DRIVE_FLAG)
/* Abstract and program Drive configuration */
val |= cfg_val & MFP_DRIVE_MASK;
if (cfg_val & MFP_PULL_FLAG)
/* Abstract and program Pullup/down configuration */
val |= cfg_val & MFP_PULL_MASK;
writel(val, p_mfpr);
} while (1);
/*
* perform a read-back of any MFPR register to make sure the
* previous writings are finished
*/
readl(p_mfpr);
}
|
