1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
|
* IMG Multi-threaded DMA Controller (MDC)
Required properties:
- compatible: Must be "img,pistachio-mdc-dma".
- reg: Must contain the base address and length of the MDC registers.
- interrupts: Must contain all the per-channel DMA interrupts.
- clocks: Must contain an entry for each entry in clock-names.
See ../clock/clock-bindings.txt for details.
- clock-names: Must include the following entries:
- sys: MDC system interface clock.
- img,cr-periph: Must contain a phandle to the peripheral control syscon
node which contains the DMA request to channel mapping registers.
- img,max-burst-multiplier: Must be the maximum supported burst size multiplier.
The maximum burst size is this value multiplied by the hardware-reported bus
width.
- #dma-cells: Must be 3:
- The first cell is the peripheral's DMA request line.
- The second cell is a bitmap specifying to which channels the DMA request
line may be mapped (i.e. bit N set indicates channel N is usable).
- The third cell is the thread ID to be used by the channel.
Optional properties:
- dma-channels: Number of supported DMA channels, up to 32. If not specified
the number reported by the hardware is used.
Example:
mdc: dma-controller@18143000 {
compatible = "img,pistachio-mdc-dma";
reg = <0x18143000 0x1000>;
interrupts = <GIC_SHARED 27 IRQ_TYPE_LEVEL_HIGH>,
<GIC_SHARED 28 IRQ_TYPE_LEVEL_HIGH>,
<GIC_SHARED 29 IRQ_TYPE_LEVEL_HIGH>,
<GIC_SHARED 30 IRQ_TYPE_LEVEL_HIGH>,
<GIC_SHARED 31 IRQ_TYPE_LEVEL_HIGH>,
<GIC_SHARED 32 IRQ_TYPE_LEVEL_HIGH>,
<GIC_SHARED 33 IRQ_TYPE_LEVEL_HIGH>,
<GIC_SHARED 34 IRQ_TYPE_LEVEL_HIGH>,
<GIC_SHARED 35 IRQ_TYPE_LEVEL_HIGH>,
<GIC_SHARED 36 IRQ_TYPE_LEVEL_HIGH>,
<GIC_SHARED 37 IRQ_TYPE_LEVEL_HIGH>,
<GIC_SHARED 38 IRQ_TYPE_LEVEL_HIGH>;
clocks = <&system_clk>;
clock-names = "sys";
img,max-burst-multiplier = <16>;
img,cr-periph = <&cr_periph>;
#dma-cells = <3>;
};
spi@18100f00 {
...
dmas = <&mdc 9 0xffffffff 0>, <&mdc 10 0xffffffff 0>;
dma-names = "tx", "rx";
...
};
|
