Age | Commit message (Collapse) | Author | Files | Lines |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
INFO: rcu_sched detected stalls on CPUs/tasks:
1-...: (11800 GPs behind) idle=45d/140000000000000/0 softirq=0/0 fqs=21663
(detected by 0, t=65016 jiffies, g=11500, c=11499, q=719)
Task dump for CPU 1:
qemu-system-x86 R running task 0 3529 3525 0x00080808
ffff8802021791a0 ffff880212895040 0000000000000001 00007f1c2c00db40
ffff8801dd20fcd3 ffffc90002b98000 ffff8801dd20fc88 ffff8801dd20fcf8
0000000000000286 ffff8801dd2ac538 ffff8801dd20fcc0 ffffffffc06949c9
Call Trace:
? kvm_write_guest_cached+0xb9/0x160 [kvm]
? __delay+0xf/0x20
? wait_lapic_expire+0x14a/0x200 [kvm]
? kvm_arch_vcpu_ioctl_run+0xcbe/0x1b00 [kvm]
? kvm_arch_vcpu_ioctl_run+0xe34/0x1b00 [kvm]
? kvm_vcpu_ioctl+0x2d3/0x7c0 [kvm]
? __fget+0x5/0x210
? do_vfs_ioctl+0x96/0x6a0
? __fget_light+0x2a/0x90
? SyS_ioctl+0x79/0x90
? do_syscall_64+0x7c/0x1e0
? entry_SYSCALL64_slow_path+0x25/0x25
This can be reproduced readily by running a full dynticks guest(since hrtimer
in guest is heavily used) w/ lapic_timer_advance disabled.
If fail to program hardware preemption timer, we will fallback to hrtimer based
method, however, a previous programmed preemption timer miss to cancel in this
scenario which results in one hardware preemption timer and one hrtimer emulated
tsc deadline timer run simultaneously. So sometimes the target guest deadline
tsc is earlier than guest tsc, which leads to the computation in vmx_set_hv_timer
can underflow and cause delta_tsc to be set a huge value, then host soft lockup
as above.
This patch fix it by cancelling the previous programmed preemption timer if there
is once we failed to program the new preemption timer and fallback to hrtimer
based method.
Cc: Paolo Bonzini <pbonzini@redhat.com>
Cc: Radim Krčmář <rkrcmar@redhat.com>
Signed-off-by: Wanpeng Li <wanpeng.li@hotmail.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Change-Id: I8a2decefab743aecdfab676fb9267324bf42b848
upstream-status: backport
Signed-off-by: Yunhong Jiang <yunhong.jiang@linux.intel.com>
|
|
Introduce cancel_hv_tscdeadline() to encapsulate preemption
timer cancel stuff.
Cc: Paolo Bonzini <pbonzini@redhat.com>
Cc: Radim Krčmář <rkrcmar@redhat.com>
Cc: Yunhong Jiang <yunhong.jiang@intel.com>
Signed-off-by: Wanpeng Li <wanpeng.li@hotmail.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Change-Id: Icc038176cbf361a9ecdf37ed3425108db57617f2
upstream-status: backport
Signed-off-by: Yunhong Jiang <yunhong.jiang@linux.intel.com>
|
|
If the TSC deadline timer is programmed really close to the deadline or
even in the past, the computation in vmx_set_hv_timer can underflow and
cause delta_tsc to be set to a huge value. This generally results
in vmx_set_hv_timer returning -ERANGE, but we can fix it by limiting
delta_tsc to be positive or zero.
Reported-by: Wanpeng Li <wanpeng.li@hotmail.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Change-Id: I12eea18c3ec648dbf782d7754b7b574d7d6aa92c
upstream-status: backport
Signed-off-by: Yunhong Jiang <yunhong.jiang@linux.intel.com>
|
|
Hook the VMX preemption timer to the "hv timer" functionality added
by the previous patch. This includes: checking if the feature is
supported, if the feature is broken on the CPU, the hooks to
setup/clean the VMX preemption timer, arming the timer on vmentry
and handling the vmexit.
A module parameter states if the VMX preemption timer should be
utilized.
Signed-off-by: Yunhong Jiang <yunhong.jiang@intel.com>
[Move hv_deadline_tsc to struct vcpu_vmx, use -1 as the "unset" value.
Put all VMX bits here. Enable it by default #yolo. - Paolo]
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Change-Id: Icb8e0b853eedce3d52c394e510fa14d2cdd432e9
upstream-status: backport
Signed-off-by: Yunhong Jiang <yunhong.jiang@linux.intel.com>
|
|
Prepare to switch from preemption timer to hrtimer in the
vmx_pre/post_block. Current functions are only for posted interrupt,
rename them accordingly.
upstream-status: backport
Change-Id: Ie1dde9be21deeb661de095e07d6c29bcba2e7d73
Signed-off-by: Yunhong Jiang <yunhong.jiang@intel.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Signed-off-by: Yunhong Jiang <yunhong.jiang@linux.intel.com>
|
|
The VMX preemption timer can be used to virtualize the TSC deadline timer.
The VMX preemption timer is armed when the vCPU is running, and a VMExit
will happen if the virtual TSC deadline timer expires.
When the vCPU thread is blocked because of HLT, KVM will switch to use
an hrtimer, and then go back to the VMX preemption timer when the vCPU
thread is unblocked.
This solution avoids the complex OS's hrtimer system, and the host
timer interrupt handling cost, replacing them with a little math
(for guest->host TSC and host TSC->preemption timer conversion)
and a cheaper VMexit. This benefits latency for isolated pCPUs.
[A word about performance... Yunhong reported a 30% reduction in average
latency from cyclictest. I made a similar test with tscdeadline_latency
from kvm-unit-tests, and measured
- ~20 clock cycles loss (out of ~3200, so less than 1% but still
statistically significant) in the worst case where the test halts
just after programming the TSC deadline timer
- ~800 clock cycles gain (25% reduction in latency) in the best case
where the test busy waits.
I removed the VMX bits from Yunhong's patch, to concentrate them in the
next patch - Paolo]
Signed-off-by: Yunhong Jiang <yunhong.jiang@intel.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Change-Id: I4aa1ecfa3463d1cbfb317511b45d2074b33d9b6f
upstream-status: backport
Signed-off-by: Yunhong Jiang <yunhong.jiang@linux.intel.com>
|
|
The function to start the tsc deadline timer virtualization will be used
also by the pre_block hook when we use the preemption timer; change it
to a separate function. No logic changes.
upstream-status: backport
Change-Id: Ie2fc19108c3252f8a299b17aba16c14aa8d31ae8
Signed-off-by: Yunhong Jiang <yunhong.jiang@intel.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Signed-off-by: Yunhong Jiang <yunhong.jiang@linux.intel.com>
|
|
In the Mitaka version of OpenStack, Neutron agent uses connmark
module to add rules into iptable. Enable this module in
opnfv.config to fix the failure of launching instances in Horizon.
Upstream status - NA
Change-Id: I31f346198a5ba50e83d10210bb5b5e10baf825f3
Signed-off-by: davidjchou <david.j.chou@intel.com>
|
|
in bare metal execution of dpdk-16.04.
Upstream: NA.
Change-Id: Ia98461b15348a667c4989dfe1399f0c5bc0f0c12
Signed-off-by: José Pekkarinen <jose.pekkarinen@nokia.com>
|
|
The OPNFV environment requires many kernel modules that are not
part of the default RT kernel environment. This patch adds those
modules back in.
Upstream status: NA
Change-Id: Id4e63f3d2dd3e19614e9e080adf1cdae9ab26ee1
|
|
This config file is based in the previous one, adding the
changes needed in the config file for this new kernel version.
It has been added in kernel support for CephFS.
Upstream: NA.
Change-Id: I1de8b4678bdfa81f4fc204f4a02d11f11cb5ae87
Signed-off-by: José Pekkarinen <jose.pekkarinen@nokia.com>
|
|
are taken from kernel.org, and rt patch from the rt wiki download page.
During the rebasing, the following patch collided:
Force tick interrupt and get rid of softirq magic(I70131fb85).
Collisions have been removed because its logic was found on the
source already.
Change-Id: I7f57a4081d9deaa0d9ccfc41a6c8daccdee3b769
Signed-off-by: José Pekkarinen <jose.pekkarinen@nokia.com>
|
|
|
|
The configuration of the kernel enables the framebuffer console without
any framebuffer selected other than i915. Adding the VESA compliant
framebuffer should fix this issue.
Change-Id: Icc384e05774e1de20985aeb19dfef25ae2431bb6
Signed-off-by: José Pekkarinen <jose.pekkarinen@nokia.com>
|
|
Change-Id: Iecc8205f443e2e47fc955c80bf6f0aa55db75447
Signed-off-by: José Pekkarinen <jose.pekkarinen@nokia.com>
|
|
OVS kernel module is important for NFV. The existed kernel config misses
several important kernel configuration, mostly for VxLAN, which is required
by the OVS kernel module.
Also add the OVS as a module, so that user can use it if needed, or replace
it when use the OPNFV patched OVS module.
Change-Id: I032f84e0468fc2614557274a50f30d502d39cc52
Signed-off-by: Yunhong Jiang <yunhong.jiang@intel.com>
|
|
Change-Id: I3e91161abafc62554e793e4851df639c099421e7
Signed-off-by: José Pekkarinen <jose.pekkarinen@nokia.com>
|
|
Change-Id: I4c0fe67609fc74fc60e6a2c99d448fd47a6d2a86
Signed-off-by: José Pekkarinen <jose.pekkarinen@nokia.com>
|
|
Change-Id: Icd51e1625a57867b2f79cb2b2d1ab21b23bd80e0
Signed-off-by: José Pekkarinen <jose.pekkarinen@nokia.com>
|
|
|
|
Kernel config is important for RT linux. A specific config
file is provided for the opnfv project to build the
reference config options.
Currently this config file is assumed to be used for
both host and guest kernel. We may split them in future.
Change-Id: Ia9ebe0bc002518bb603af8901c6f31531d2f0cee
Signed-off-by: Yunhong Jiang <yunhong.jiang@intel.com>
|
|
recently announced rt patch patch-4.1.10-rt10.patch. No further changes
needed.
Change-Id: I9a0cf084498133b10771e744b6da4b29dff706ba
Signed-off-by: José Pekkarinen <jose.pekkarinen@nokia.com>
|
|
These changes brings a vanilla kernel from kernel.org, and the patch
applied for rt is patch-4.1.7-rt8.patch. No further changes needed.
Change-Id: Id8dd03c2ddd971e4d1d69b905f3069737053b700
Signed-off-by: José Pekkarinen <jose.pekkarinen@nokia.com>
|
|
Import the rt linux 4.1.3-rt3 as OPNFV kvm base.
It's from git://git.kernel.org/pub/scm/linux/kernel/git/rt/linux-rt-devel.git linux-4.1.y-rt and
the base is:
commit 0917f823c59692d751951bf5ea699a2d1e2f26a2
Author: Sebastian Andrzej Siewior <bigeasy@linutronix.de>
Date: Sat Jul 25 12:13:34 2015 +0200
Prepare v4.1.3-rt3
Signed-off-by: Sebastian Andrzej Siewior <bigeasy@linutronix.de>
We lose all the git history this way and it's not good. We
should apply another opnfv project repo in future.
Change-Id: I87543d81c9df70d99c5001fbdf646b202c19f423
Signed-off-by: Yunhong Jiang <yunhong.jiang@intel.com>
|