diff options
Diffstat (limited to 'qemu/roms/u-boot/include/configs/amcc-common.h')
| -rw-r--r-- | qemu/roms/u-boot/include/configs/amcc-common.h | 256 |
1 files changed, 0 insertions, 256 deletions
diff --git a/qemu/roms/u-boot/include/configs/amcc-common.h b/qemu/roms/u-boot/include/configs/amcc-common.h deleted file mode 100644 index 2aea89937..000000000 --- a/qemu/roms/u-boot/include/configs/amcc-common.h +++ /dev/null @@ -1,256 +0,0 @@ -/* - * (C) Copyright 2008, 2009 - * Stefan Roese, DENX Software Engineering, sr@denx.de. - * - * Common configuration options for all AMCC boards - * - * SPDX-License-Identifier: GPL-2.0+ - */ - -#ifndef __AMCC_COMMON_H -#define __AMCC_COMMON_H - -#define CONFIG_SYS_SDRAM_BASE 0x00000000 /* _must_ be 0 */ -#define CONFIG_SYS_MONITOR_BASE CONFIG_SYS_TEXT_BASE /* Start of U-Boot */ -#define CONFIG_SYS_MONITOR_LEN (0xFFFFFFFF - CONFIG_SYS_MONITOR_BASE + 1) -#define CONFIG_SYS_MALLOC_LEN (1 << 20) /* Reserved for malloc */ - -/* - * UART - */ -#define CONFIG_SYS_NS16550 -#define CONFIG_SYS_NS16550_SERIAL -#define CONFIG_SYS_NS16550_REG_SIZE 1 -#define CONFIG_SYS_NS16550_CLK get_serial_clock() -#define CONFIG_BAUDRATE 115200 -#define CONFIG_SYS_BAUDRATE_TABLE \ - {300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200, 230400} - -/* - * I2C - */ -#define CONFIG_SYS_I2C -#define CONFIG_SYS_I2C_PPC4XX -#define CONFIG_SYS_I2C_PPC4XX_CH0 -#define CONFIG_SYS_I2C_PPC4XX_SLAVE_0 0x7F - -/* - * Ethernet/EMAC/PHY - */ -#define CONFIG_PPC4xx_EMAC -#define CONFIG_MII /* MII PHY management */ -#define CONFIG_NETCONSOLE /* include NetConsole support */ -#if defined(CONFIG_440) -#define CONFIG_SYS_RX_ETH_BUFFER 32 /* number of eth rx buffers */ -#else -#define CONFIG_SYS_RX_ETH_BUFFER 16 /* number of eth rx buffers */ -#endif - -/* - * Commands - */ -#include <config_cmd_default.h> - -#define CONFIG_CMD_ASKENV -#if defined(CONFIG_440) -#define CONFIG_CMD_CACHE -#endif -#define CONFIG_CMD_DHCP -#define CONFIG_CMD_DIAG -#define CONFIG_CMD_EEPROM -#define CONFIG_CMD_ELF -#define CONFIG_CMD_GREPENV -#define CONFIG_CMD_I2C -#define CONFIG_CMD_IRQ -#define CONFIG_CMD_MII -#define CONFIG_CMD_NET -#define CONFIG_CMD_NFS -#define CONFIG_CMD_PING -#define CONFIG_CMD_REGINFO -#define CONFIG_CMD_SETEXPR - -/* - * Miscellaneous configurable options - */ -#define CONFIG_BOOTDELAY 5 /* autoboot after 5 seconds */ -#define CONFIG_SYS_LONGHELP /* undef to save memory */ -#if defined(CONFIG_CMD_KGDB) -#define CONFIG_SYS_CBSIZE 1024 /* Console I/O Buffer Size */ -#else -#define CONFIG_SYS_CBSIZE 256 /* Console I/O Buffer Size */ -#endif -#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16) -#define CONFIG_SYS_MAXARGS 16 /* max number of command args */ -#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Boot Argument Buffer Size */ - -#define CONFIG_SYS_MEMTEST_START 0x0400000 /* memtest works on */ -#define CONFIG_SYS_MEMTEST_END 0x0C00000 /* 4 ... 12 MB in DRAM */ - -#define CONFIG_SYS_LOAD_ADDR 0x100000 /* default load address */ -#define CONFIG_SYS_EXTBDINFO /* To use extended board_into (bd_t) */ - -#define CONFIG_CMDLINE_EDITING /* add command line history */ -#define CONFIG_AUTO_COMPLETE /* add autocompletion support */ -#define CONFIG_LOOPW /* enable loopw command */ -#define CONFIG_MX_CYCLIC /* enable mdc/mwc commands */ -#define CONFIG_ZERO_BOOTDELAY_CHECK /* check for keypress on bootdelay==0 */ -#define CONFIG_VERSION_VARIABLE /* include version env variable */ -#define CONFIG_SYS_CONSOLE_INFO_QUIET /* don't print console @ startup*/ - -#define CONFIG_SYS_HUSH_PARSER /* Use the HUSH parser */ - -#define CONFIG_LOADS_ECHO /* echo on for serial download */ -#define CONFIG_SYS_LOADS_BAUD_CHANGE /* allow baudrate change */ - -#define CONFIG_REGEX /* Enable regular expression support */ -/* - * BOOTP options - */ -#define CONFIG_BOOTP_BOOTFILESIZE -#define CONFIG_BOOTP_BOOTPATH -#define CONFIG_BOOTP_GATEWAY -#define CONFIG_BOOTP_HOSTNAME -#define CONFIG_BOOTP_SUBNETMASK - -/* - * For booting Linux, the board info and command line data - * have to be in the first 16 MB of memory, since this is - * the maximum mapped by the 40x Linux kernel during initialization. - */ -#define CONFIG_SYS_BOOTMAPSZ (16 << 20) /* Initial Memory map for Linux */ -#define CONFIG_SYS_BOOTM_LEN (16 << 20) /* Increase max gunzip size */ - -/* - * Internal Definitions - */ -#if defined(CONFIG_CMD_KGDB) -#define CONFIG_KGDB_BAUDRATE 230400 /* speed to run kgdb serial port*/ -#endif - -/* - * Pass open firmware flat tree - */ -#define CONFIG_OF_LIBFDT -#define CONFIG_OF_BOARD_SETUP -/* Update size in "reg" property of NOR FLASH device tree nodes */ -#define CONFIG_FDT_FIXUP_NOR_FLASH_SIZE - -/* - * Booting and default environment - */ -#define CONFIG_PREBOOT "echo;" \ - "echo Type \"run flash_nfs\" to mount root filesystem over NFS;" \ - "echo" -#define CONFIG_BOOTCOMMAND "run flash_self" - -/* - * Only very few boards have default console not on ttyS0 (like Taishan) - */ -#if !defined(CONFIG_USE_TTY) -#define CONFIG_USE_TTY ttyS0 -#endif - -/* - * Only very few boards have default netdev not set to eth0 (like Arches) - */ -#if !defined(CONFIG_USE_NETDEV) -#define CONFIG_USE_NETDEV eth0 -#endif - -/* - * Only some 4xx PPC's are equipped with an FPU - */ -#if defined(CONFIG_440EP) || defined(CONFIG_440EPX) || \ - defined(CONFIG_460EX) || defined(CONFIG_460GT) -#define CONFIG_AMCC_DEF_ENV_ROOTPATH "rootpath=/opt/eldk/ppc_4xxFP\0" -#else -#define CONFIG_AMCC_DEF_ENV_ROOTPATH "rootpath=/opt/eldk/ppc_4xx\0" -#endif - -/* - * Only some boards need to extend the bootargs by some additional - * parameters (like Makalu) - */ -#if !defined(CONFIG_ADDMISC) -#define CONFIG_ADDMISC "addmisc=setenv bootargs ${bootargs}\0" -#endif - -/* - * General common environment variables shared on all AMCC eval boards - */ -#define CONFIG_AMCC_DEF_ENV \ - "netdev=" __stringify(CONFIG_USE_NETDEV) "\0" \ - "nfsargs=setenv bootargs root=/dev/nfs rw " \ - "nfsroot=${serverip}:${rootpath}\0" \ - "ramargs=setenv bootargs root=/dev/ram rw\0" \ - "addip=setenv bootargs ${bootargs} " \ - "ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}" \ - ":${hostname}:${netdev}:off panic=1\0" \ - "addtty=setenv bootargs ${bootargs}" \ - " console=" __stringify(CONFIG_USE_TTY) ",${baudrate}\0" \ - CONFIG_ADDMISC \ - "initrd_high=30000000\0" \ - "kernel_addr_r=1000000\0" \ - "fdt_addr_r=1800000\0" \ - "ramdisk_addr_r=1900000\0" \ - "hostname=" __stringify(CONFIG_HOSTNAME) "\0" \ - "bootfile=" __stringify(CONFIG_HOSTNAME) "/uImage\0" \ - "ramdisk_file=" __stringify(CONFIG_HOSTNAME) "/uRamdisk\0" \ - CONFIG_AMCC_DEF_ENV_ROOTPATH - -/* - * Default environment for arch/powerpc booting - * for boards that are ported to arch/powerpc - */ -#define CONFIG_AMCC_DEF_ENV_POWERPC \ - "flash_self=run ramargs addip addtty addmisc;" \ - "bootm ${kernel_addr} ${ramdisk_addr} ${fdt_addr}\0" \ - "flash_nfs=run nfsargs addip addtty addmisc;" \ - "bootm ${kernel_addr} - ${fdt_addr}\0" \ - "net_nfs=tftp ${kernel_addr_r} ${bootfile}; " \ - "tftp ${fdt_addr_r} ${fdt_file}; " \ - "run nfsargs addip addtty addmisc;" \ - "bootm ${kernel_addr_r} - ${fdt_addr_r}\0" \ - "net_self_load=tftp ${kernel_addr_r} ${bootfile};" \ - "tftp ${fdt_addr_r} ${fdt_file};" \ - "tftp ${ramdisk_addr_r} ${ramdisk_file};\0" \ - "net_self=run net_self_load;" \ - "run ramargs addip addtty addmisc;" \ - "bootm ${kernel_addr_r} ${ramdisk_addr_r} ${fdt_addr_r}\0" \ - "fdt_file=" __stringify(CONFIG_HOSTNAME) "/" __stringify(CONFIG_HOSTNAME) ".dtb\0" - -/* - * Default environment for arch/ppc booting, - * for boards that are not ported to arch/powerpc yet - */ -#define CONFIG_AMCC_DEF_ENV_PPC \ - "flash_self=run ramargs addip addtty addmisc;" \ - "bootm ${kernel_addr} ${ramdisk_addr}\0" \ - "flash_nfs=run nfsargs addip addtty addmisc;" \ - "bootm ${kernel_addr}\0" \ - "net_nfs=tftp ${kernel_addr_r} ${bootfile};" \ - "run nfsargs addip addtty addmisc;" \ - "bootm ${kernel_addr_r}\0" - -/* - * Default environment for arch/ppc booting (old version), - * for boards that are ported to arch/ppc and arch/powerpc - */ -#define CONFIG_AMCC_DEF_ENV_PPC_OLD \ - "flash_self_old=run ramargs addip addtty addmisc;" \ - "bootm ${kernel_addr} ${ramdisk_addr}\0" \ - "flash_nfs_old=run nfsargs addip addtty addmisc;" \ - "bootm ${kernel_addr}\0" \ - "net_nfs_old=tftp ${kernel_addr_r} ${bootfile};" \ - "run nfsargs addip addtty addmisc;" \ - "bootm ${kernel_addr_r}\0" - -#define CONFIG_AMCC_DEF_ENV_NOR_UPD \ - "u-boot=" __stringify(CONFIG_HOSTNAME) "/u-boot.bin\0" \ - "load=tftp 200000 ${u-boot}\0" \ - "update=protect off " __stringify(CONFIG_SYS_MONITOR_BASE) " FFFFFFFF;" \ - "era " __stringify(CONFIG_SYS_MONITOR_BASE) " FFFFFFFF;" \ - "cp.b ${fileaddr} " __stringify(CONFIG_SYS_MONITOR_BASE) " ${filesize}\0" \ - "upd=run load update\0" \ - -#endif /* __AMCC_COMMON_H */ |