diff options
Diffstat (limited to 'qemu/roms/u-boot/doc/README.Modem')
| -rw-r--r-- | qemu/roms/u-boot/doc/README.Modem | 72 |
1 files changed, 0 insertions, 72 deletions
diff --git a/qemu/roms/u-boot/doc/README.Modem b/qemu/roms/u-boot/doc/README.Modem deleted file mode 100644 index 1613c11ca..000000000 --- a/qemu/roms/u-boot/doc/README.Modem +++ /dev/null @@ -1,72 +0,0 @@ -How to configure modem support in U-Boot : - -1. Define modem initialization strings: ---------------------------------------- - -The modem initialization strings have following format: - - mdm_init1=<AT-command> - mdm_init2=<AT-command> - ... - -Turning off modem verbose responses with ATV0 or ATQ1 is not allowed; -U-Boot analyzes only verbose (not numeric) result codes. Modem local -command echo can be turned off (ATE0). - -2. RTS/CTS hardware flow control: ---------------------------------- - -You may wish to enable RTS/CTS hardware flow control, if the board's -UART driver supports it (see CONFIG_HWFLOW compile-time flag in -config/<board>.h). This is controlled by the 'mdm_flow_control' -environment variable: - - 'mdm_flow_control=rts/cts' - to enable RTS/CTS flow control. - 'mdm_flow_control=none ' - to disable. - - -The following are the examples using a Rockwell OEM modem -configuration: - -SAMSUNG # setenv mdm_init1 ATZ - reset the modem to - the factory defaults. -SAMSUNG # setenv mdm_init2 ATS0=1 - set modem into - answer mode. -SAMSUNG # setenv mdm_flow_control rts/cts - enable serial port - flow control -SAMSUNG # saveenv - -The example above initializes modem into answer mode to wait for the -incoming call. RTS/CTS flow control is enabled for the serial port. -(The RTS/CTS flow control is enabled by default on the modem). - - -SAMSUNG # setenv mdm_init1 ATZ -SAMSUNG # setenv mdm_init2 ATS39=0+IFC=0,0 - disable modem - RTS/CTS flow control -SAMSUNG # setenv mdm_init3 ATDT1643973 - dial out the number -SAMSUNG # setenv mdm_flow_control none -SAMSUNG # saveenv - -The example above initializes modem to dial-up connection on the -number 1643973. Flow control is disabled. - -Note that flow control must be turned both off or both on for the -board serial port and for the modem. - - -If the connection was set up successfully, the U-Boot prompt appears -on the terminal console. If not (U-Boot modem was configured for -originating the call and connection was not established) - the board -should be reset for another dial-up try. - - -Note on the SMDK2400 board: ---------------------------- - -Since the board serial ports does not have DTR signal wired, modem -should be told to ignore port DTR setting prior to connection to the -SMDK board, and this setting should be stored in modem NVRAM. For the -Rockwell OEM modem this can to be done with the following command: - -AT&D0&W |