diff options
Diffstat (limited to 'qemu/roms/u-boot/board/wandboard/README')
| -rw-r--r-- | qemu/roms/u-boot/board/wandboard/README | 45 |
1 files changed, 0 insertions, 45 deletions
diff --git a/qemu/roms/u-boot/board/wandboard/README b/qemu/roms/u-boot/board/wandboard/README deleted file mode 100644 index 1f678e16a..000000000 --- a/qemu/roms/u-boot/board/wandboard/README +++ /dev/null @@ -1,45 +0,0 @@ -U-Boot for Wandboard --------------------- - -This file contains information for the port of U-Boot to the Wandboard. - -Wandboard is a development board that has three variants based on the following -SoCs: mx6 quad, mx6 dual lite and mx6 solo. - -For more details about Wandboard, please refer to: -http://www.wandboard.org/ - -Building U-boot for Wandboard ------------------------------ - -To build U-Boot for the Wandboard Dual Lite version: - -$ make wandboard_dl_config -$ make - -To build U-Boot for the Wandboard Solo version: - -$ make wandboard_solo_config -$ make - -To build U-Boot for the Wandboard Quad version: - -$ make wandboard_quad_config -$ make - -Flashing U-boot into the SD card --------------------------------- - -- After the 'make' command completes, the generated 'u-boot.imx' binary must be -flashed into the SD card; - -$ sudo dd if=u-boot.imx of=/dev/mmcblk0 bs=512 seek=2; sync - -(Note - the SD card node may vary, so adjust this as needed). - -- Insert the SD card into the slot located in the bottom of the board (same side -as the mx6 processor) - -- Connect the serial cable to the host PC - -- Power up the board and U-boot messages will appear in the serial console. |