diff options
Diffstat (limited to 'qemu/roms/u-boot/board/wandboard/README')
| -rw-r--r-- | qemu/roms/u-boot/board/wandboard/README | 45 |
1 files changed, 45 insertions, 0 deletions
diff --git a/qemu/roms/u-boot/board/wandboard/README b/qemu/roms/u-boot/board/wandboard/README new file mode 100644 index 000000000..1f678e16a --- /dev/null +++ b/qemu/roms/u-boot/board/wandboard/README @@ -0,0 +1,45 @@ +U-Boot for Wandboard +-------------------- + +This file contains information for the port of U-Boot to the Wandboard. + +Wandboard is a development board that has three variants based on the following +SoCs: mx6 quad, mx6 dual lite and mx6 solo. + +For more details about Wandboard, please refer to: +http://www.wandboard.org/ + +Building U-boot for Wandboard +----------------------------- + +To build U-Boot for the Wandboard Dual Lite version: + +$ make wandboard_dl_config +$ make + +To build U-Boot for the Wandboard Solo version: + +$ make wandboard_solo_config +$ make + +To build U-Boot for the Wandboard Quad version: + +$ make wandboard_quad_config +$ make + +Flashing U-boot into the SD card +-------------------------------- + +- After the 'make' command completes, the generated 'u-boot.imx' binary must be +flashed into the SD card; + +$ sudo dd if=u-boot.imx of=/dev/mmcblk0 bs=512 seek=2; sync + +(Note - the SD card node may vary, so adjust this as needed). + +- Insert the SD card into the slot located in the bottom of the board (same side +as the mx6 processor) + +- Connect the serial cable to the host PC + +- Power up the board and U-boot messages will appear in the serial console. |