diff options
Diffstat (limited to 'kernel/tools/testing/ktest/examples/kvm.conf')
| -rw-r--r-- | kernel/tools/testing/ktest/examples/kvm.conf | 92 |
1 files changed, 92 insertions, 0 deletions
diff --git a/kernel/tools/testing/ktest/examples/kvm.conf b/kernel/tools/testing/ktest/examples/kvm.conf new file mode 100644 index 000000000..fbc134f9a --- /dev/null +++ b/kernel/tools/testing/ktest/examples/kvm.conf @@ -0,0 +1,92 @@ +# +# This config is an example usage of ktest.pl with a kvm guest +# +# The guest is called 'Guest' and this would be something that +# could be run on the host to test a virtual machine target. + +MACHINE = Guest + + +# Use virsh to read the serial console of the guest +CONSOLE = virsh console ${MACHINE} + +# Use SIGKILL to terminate virsh console. We can't kill virsh console +# by the default signal, SIGINT. +CLOSE_CONSOLE_SIGNAL = KILL + +#*************************************# +# This part is the same as test.conf # +#*************************************# + +# The include files will set up the type of test to run. Just set TEST to +# which test you want to run. +# +# TESTS = patchcheck, randconfig, boot, test, config-bisect, bisect, min-config +# +# See the include/*.conf files that define these tests +# +TEST := patchcheck + +# Some tests may have more than one test to run. Define MULTI := 1 to run +# the extra tests. +MULTI := 0 + +# In case you want to differentiate which type of system you are testing +BITS := 64 + +# REBOOT = none, error, fail, empty +# See include/defaults.conf +REBOOT := empty + + +# The defaults file will set up various settings that can be used by all +# machine configs. +INCLUDE include/defaults.conf + + +#*************************************# +# Now we are different from test.conf # +#*************************************# + + +# The example here assumes that Guest is running a Fedora release +# that uses dracut for its initfs. The POST_INSTALL will be executed +# after the install of the kernel and modules are complete. +# +POST_INSTALL = ${SSH} /sbin/dracut -f /boot/initramfs-test.img $KERNEL_VERSION + +# Guests sometimes get stuck on reboot. We wait 3 seconds after running +# the reboot command and then do a full power-cycle of the guest. +# This forces the guest to restart. +# +POWERCYCLE_AFTER_REBOOT = 3 + +# We do the same after the halt command, but this time we wait 20 seconds. +POWEROFF_AFTER_HALT = 20 + + +# As the defaults.conf file has a POWER_CYCLE option already defined, +# and options can not be defined in the same section more than once +# (all DEFAULTS sections are considered the same). We use the +# DEFAULTS OVERRIDE to tell ktest.pl to ignore the previous defined +# options, for the options set in the OVERRIDE section. +# +DEFAULTS OVERRIDE + +# Instead of using the default POWER_CYCLE option defined in +# defaults.conf, we use virsh to cycle it. To do so, we destroy +# the guest, wait 5 seconds, and then start it up again. +# Crude, but effective. +# +POWER_CYCLE = virsh destroy ${MACHINE}; sleep 5; virsh start ${MACHINE} + + +DEFAULTS + +# The following files each handle a different test case. +# Having them included allows you to set up more than one machine and share +# the same tests. +INCLUDE include/patchcheck.conf +INCLUDE include/tests.conf +INCLUDE include/bisect.conf +INCLUDE include/min-config.conf |