diff options
Diffstat (limited to 'kernel/include/linux/regulator/driver.h')
| -rw-r--r-- | kernel/include/linux/regulator/driver.h | 14 |
1 files changed, 14 insertions, 0 deletions
diff --git a/kernel/include/linux/regulator/driver.h b/kernel/include/linux/regulator/driver.h index fffa688ac..9c2903e58 100644 --- a/kernel/include/linux/regulator/driver.h +++ b/kernel/include/linux/regulator/driver.h @@ -91,6 +91,7 @@ struct regulator_linear_range { * @set_current_limit: Configure a limit for a current-limited regulator. * The driver should select the current closest to max_uA. * @get_current_limit: Get the configured limit for a current-limited regulator. + * @set_input_current_limit: Configure an input limit. * * @set_mode: Set the configured operating mode for the regulator. * @get_mode: Get the configured operating mode for the regulator. @@ -111,6 +112,7 @@ struct regulator_linear_range { * to stabilise after being set to a new value, in microseconds. * The function provides the from and to voltage selector, the * function should return the worst case. + * @set_soft_start: Enable soft start for the regulator. * * @set_suspend_voltage: Set the voltage for the regulator when the system * is suspended. @@ -121,6 +123,9 @@ struct regulator_linear_range { * @set_suspend_mode: Set the operating mode for the regulator when the * system is suspended. * + * @set_pull_down: Configure the regulator to pull down when the regulator + * is disabled. + * * This struct describes regulator operations which can be implemented by * regulator chip drivers. */ @@ -142,6 +147,9 @@ struct regulator_ops { int min_uA, int max_uA); int (*get_current_limit) (struct regulator_dev *); + int (*set_input_current_limit) (struct regulator_dev *, int lim_uA); + int (*set_over_current_protection) (struct regulator_dev *); + /* enable/disable regulator */ int (*enable) (struct regulator_dev *); int (*disable) (struct regulator_dev *); @@ -158,6 +166,8 @@ struct regulator_ops { unsigned int old_selector, unsigned int new_selector); + int (*set_soft_start) (struct regulator_dev *); + /* report regulator status ... most other accessors report * control inputs, this reports results of combining inputs * from Linux (and other sources) with the actual load. @@ -187,6 +197,8 @@ struct regulator_ops { /* set regulator suspend operating mode (defined in consumer.h) */ int (*set_suspend_mode) (struct regulator_dev *, unsigned int mode); + + int (*set_pull_down) (struct regulator_dev *); }; /* @@ -233,6 +245,7 @@ enum regulator_type { * @linear_min_sel: Minimal selector for starting linear mapping * @fixed_uV: Fixed voltage of rails. * @ramp_delay: Time to settle down after voltage change (unit: uV/us) + * @min_dropout_uV: The minimum dropout voltage this regulator can handle * @linear_ranges: A constant table of possible voltage ranges. * @n_linear_ranges: Number of entries in the @linear_ranges table. * @volt_table: Voltage mapping table (if table based mapping) @@ -280,6 +293,7 @@ struct regulator_desc { unsigned int linear_min_sel; int fixed_uV; unsigned int ramp_delay; + int min_dropout_uV; const struct regulator_linear_range *linear_ranges; int n_linear_ranges; |