6 files changed, 27 insertions, 37 deletions

diff --git a/kernel/drivers/tty/n_tty.c b/kernel/drivers/tty/n_tty.c
index 396344cb0..16ed0b6c7 100644
--- a/kernel/drivers/tty/n_tty.c
+++ b/kernel/drivers/tty/n_tty.c
@@ -1108,19 +1108,29 @@ static void eraser(unsigned char c, struct tty_struct *tty)
  *	Locking: ctrl_lock
  */
 
-static void isig(int sig, struct tty_struct *tty)
+static void __isig(int sig, struct tty_struct *tty)
 {
-	struct n_tty_data *ldata = tty->disc_data;
 	struct pid *tty_pgrp = tty_get_pgrp(tty);
 	if (tty_pgrp) {
 		kill_pgrp(tty_pgrp, sig, 1);
 		put_pid(tty_pgrp);
 	}
+}
 
-	if (!L_NOFLSH(tty)) {
+static void isig(int sig, struct tty_struct *tty)
+{
+	struct n_tty_data *ldata = tty->disc_data;
+
+	if (L_NOFLSH(tty)) {
+		/* signal only */
+		__isig(sig, tty);
+
+	} else { /* signal and flush */
 		up_read(&tty->termios_rwsem);
 		down_write(&tty->termios_rwsem);
 
+		__isig(sig, tty);
+
 		/* clear echo buffer */
 		mutex_lock(&ldata->output_lock);
 		ldata->echo_head = ldata->echo_tail = 0;
diff --git a/kernel/drivers/tty/serial/Kconfig b/kernel/drivers/tty/serial/Kconfig
index f8120c1bd..8cd35348f 100644
--- a/kernel/drivers/tty/serial/Kconfig
+++ b/kernel/drivers/tty/serial/Kconfig
@@ -241,7 +241,6 @@ config SERIAL_SAMSUNG
 	tristate "Samsung SoC serial support"
 	depends on PLAT_SAMSUNG || ARCH_EXYNOS
 	select SERIAL_CORE
-	select SERIAL_EARLYCON
 	help
 	  Support for the on-chip UARTs on the Samsung S3C24XX series CPUs,
 	  providing /dev/ttySAC0, 1 and 2 (note, some machines may not
@@ -277,6 +276,7 @@ config SERIAL_SAMSUNG_CONSOLE
 	bool "Support for console on Samsung SoC serial port"
 	depends on SERIAL_SAMSUNG=y
 	select SERIAL_CORE_CONSOLE
+	select SERIAL_EARLYCON
 	help
 	  Allow selection of the S3C24XX on-board serial ports for use as
 	  an virtual console.
diff --git a/kernel/drivers/tty/serial/atmel_serial.c b/kernel/drivers/tty/serial/atmel_serial.c
index 27dade296..5ca1dfb05 100644
--- a/kernel/drivers/tty/serial/atmel_serial.c
+++ b/kernel/drivers/tty/serial/atmel_serial.c
@@ -315,8 +315,7 @@ static int atmel_config_rs485(struct uart_port *port,
 	if (rs485conf->flags & SER_RS485_ENABLED) {
 		dev_dbg(port->dev, "Setting UART to RS485\n");
 		atmel_port->tx_done_mask = ATMEL_US_TXEMPTY;
-		if ((rs485conf->delay_rts_after_send) > 0)
-			UART_PUT_TTGR(port, rs485conf->delay_rts_after_send);
+		UART_PUT_TTGR(port, rs485conf->delay_rts_after_send);
 		mode |= ATMEL_US_USMODE_RS485;
 	} else {
 		dev_dbg(port->dev, "Setting UART to RS232\n");
@@ -354,8 +353,7 @@ static void atmel_set_mctrl(struct uart_port *port, u_int mctrl)
 
 	/* override mode to RS485 if needed, otherwise keep the current mode */
 	if (port->rs485.flags & SER_RS485_ENABLED) {
-		if ((port->rs485.delay_rts_after_send) > 0)
-			UART_PUT_TTGR(port, port->rs485.delay_rts_after_send);
+		UART_PUT_TTGR(port, port->rs485.delay_rts_after_send);
 		mode &= ~ATMEL_US_USMODE;
 		mode |= ATMEL_US_USMODE_RS485;
 	}
@@ -2061,8 +2059,7 @@ static void atmel_set_termios(struct uart_port *port, struct ktermios *termios,
 
 	/* mode */
 	if (port->rs485.flags & SER_RS485_ENABLED) {
-		if ((port->rs485.delay_rts_after_send) > 0)
-			UART_PUT_TTGR(port, port->rs485.delay_rts_after_send);
+		UART_PUT_TTGR(port, port->rs485.delay_rts_after_send);
 		mode |= ATMEL_US_USMODE_RS485;
 	} else if (termios->c_cflag & CRTSCTS) {
 		/* RS232 with hardware handshake (RTS/CTS) */
diff --git a/kernel/drivers/tty/serial/imx.c b/kernel/drivers/tty/serial/imx.c
index 88250395b..01aa52f57 100644
--- a/kernel/drivers/tty/serial/imx.c
+++ b/kernel/drivers/tty/serial/imx.c
@@ -1132,11 +1132,6 @@ static int imx_startup(struct uart_port *port)
 	while (!(readl(sport->port.membase + UCR2) & UCR2_SRST) && (--i > 0))
 		udelay(1);
 
-	/* Can we enable the DMA support? */
-	if (is_imx6q_uart(sport) && !uart_console(port) &&
-	    !sport->dma_is_inited)
-		imx_uart_dma_init(sport);
-
 	spin_lock_irqsave(&sport->port.lock, flags);
 
 	/*
@@ -1145,9 +1140,6 @@ static int imx_startup(struct uart_port *port)
 	writel(USR1_RTSD, sport->port.membase + USR1);
 	writel(USR2_ORE, sport->port.membase + USR2);
 
-	if (sport->dma_is_inited && !sport->dma_is_enabled)
-		imx_enable_dma(sport);
-
 	temp = readl(sport->port.membase + UCR1);
 	temp |= UCR1_RRDYEN | UCR1_RTSDEN | UCR1_UARTEN;
 
@@ -1318,6 +1310,11 @@ imx_set_termios(struct uart_port *port, struct ktermios *termios,
 			} else {
 				ucr2 |= UCR2_CTSC;
 			}
+
+			/* Can we enable the DMA support? */
+			if (is_imx6q_uart(sport) && !uart_console(port)
+				&& !sport->dma_is_inited)
+				imx_uart_dma_init(sport);
 		} else {
 			termios->c_cflag &= ~CRTSCTS;
 		}
@@ -1434,6 +1431,8 @@ imx_set_termios(struct uart_port *port, struct ktermios *termios,
 	if (UART_ENABLE_MS(&sport->port, termios->c_cflag))
 		imx_enable_ms(&sport->port);
 
+	if (sport->dma_is_inited && !sport->dma_is_enabled)
+		imx_enable_dma(sport);
 	spin_unlock_irqrestore(&sport->port.lock, flags);
 }
 
diff --git a/kernel/drivers/tty/serial/serial_core.c b/kernel/drivers/tty/serial/serial_core.c
index 0b7bb12df..ec540445b 100644
--- a/kernel/drivers/tty/serial/serial_core.c
+++ b/kernel/drivers/tty/serial/serial_core.c
@@ -1409,7 +1409,7 @@ static void uart_close(struct tty_struct *tty, struct file *filp)
 	mutex_lock(&port->mutex);
 	uart_shutdown(tty, state);
 	tty_port_tty_set(port, NULL);
-	tty->closing = 0;
+
 	spin_lock_irqsave(&port->lock, flags);
 
 	if (port->blocked_open) {
@@ -1435,6 +1435,7 @@ static void uart_close(struct tty_struct *tty, struct file *filp)
 	mutex_unlock(&port->mutex);
 
 	tty_ldisc_flush(tty);
+	tty->closing = 0;
 }
 
 static void uart_wait_until_sent(struct tty_struct *tty, int timeout)
diff --git a/kernel/drivers/tty/sysrq.c b/kernel/drivers/tty/sysrq.c
index 843f2cdc2..9ffdfcf2e 100644
--- a/kernel/drivers/tty/sysrq.c
+++ b/kernel/drivers/tty/sysrq.c
@@ -55,9 +55,6 @@
 static int __read_mostly sysrq_enabled = CONFIG_MAGIC_SYSRQ_DEFAULT_ENABLE;
 static bool __read_mostly sysrq_always_enabled;
 
-unsigned short platform_sysrq_reset_seq[] __weak = { KEY_RESERVED };
-int sysrq_reset_downtime_ms __weak;
-
 static bool sysrq_on(void)
 {
 	return sysrq_enabled || sysrq_always_enabled;
@@ -569,6 +566,7 @@ void handle_sysrq(int key)
 EXPORT_SYMBOL(handle_sysrq);
 
 #ifdef CONFIG_INPUT
+static int sysrq_reset_downtime_ms;
 
 /* Simple translation table for the SysRq keys */
 static const unsigned char sysrq_xlate[KEY_CNT] =
@@ -949,23 +947,8 @@ static bool sysrq_handler_registered;
 
 static inline void sysrq_register_handler(void)
 {
-	unsigned short key;
 	int error;
-	int i;
-
-	/* First check if a __weak interface was instantiated. */
-	for (i = 0; i < ARRAY_SIZE(sysrq_reset_seq); i++) {
-		key = platform_sysrq_reset_seq[i];
-		if (key == KEY_RESERVED || key > KEY_MAX)
-			break;
-
-		sysrq_reset_seq[sysrq_reset_seq_len++] = key;
-	}
 
-	/*
-	 * DT configuration takes precedence over anything that would
-	 * have been defined via the __weak interface.
-	 */
 	sysrq_of_get_keyreset_config();
 
 	error = input_register_handler(&sysrq_handler);