diff options
Diffstat (limited to 'kernel/drivers/clk/Kconfig')
| -rw-r--r-- | kernel/drivers/clk/Kconfig | 50 |
1 files changed, 45 insertions, 5 deletions
diff --git a/kernel/drivers/clk/Kconfig b/kernel/drivers/clk/Kconfig index 9897f353b..c3e3a02f7 100644 --- a/kernel/drivers/clk/Kconfig +++ b/kernel/drivers/clk/Kconfig @@ -14,6 +14,7 @@ config COMMON_CLK select HAVE_CLK_PREPARE select CLKDEV_LOOKUP select SRCU + select RATIONAL ---help--- The common clock framework is a single definition of struct clk, useful across many platforms, as well as an @@ -59,6 +60,16 @@ config COMMON_CLK_RK808 clocked at 32KHz each. Clkout1 is always on, Clkout2 can off by control register. +config COMMON_CLK_SCPI + tristate "Clock driver controlled via SCPI interface" + depends on ARM_SCPI_PROTOCOL || COMPILE_TEST + ---help--- + This driver provides support for clocks that are controlled + by firmware that implements the SCPI interface. + + This driver uses SCPI Message Protocol to interact with the + firmware providing all the clock controls. + config COMMON_CLK_SI5351 tristate "Clock driver for SiLabs 5351A/B/C" depends on I2C @@ -68,6 +79,16 @@ config COMMON_CLK_SI5351 This driver supports Silicon Labs 5351A/B/C programmable clock generators. +config COMMON_CLK_SI514 + tristate "Clock driver for SiLabs 514 devices" + depends on I2C + depends on OF + select REGMAP_I2C + help + ---help--- + This driver supports the Silicon Labs 514 programmable clock + generator. + config COMMON_CLK_SI570 tristate "Clock driver for SiLabs 570 and compatible devices" depends on I2C @@ -78,6 +99,23 @@ config COMMON_CLK_SI570 This driver supports Silicon Labs 570/571/598/599 programmable clock generators. +config COMMON_CLK_CDCE925 + tristate "Clock driver for TI CDCE925 devices" + depends on I2C + depends on OF + select REGMAP_I2C + help + ---help--- + This driver supports the TI CDCE925 programmable clock synthesizer. + The chip contains two PLLs with spread-spectrum clocking support and + five output dividers. The driver only supports the following setup, + and uses a fixed setting for the output muxes. + Y1 is derived from the input clock + Y2 and Y3 derive from PLL1 + Y4 and Y5 derive from PLL2 + Given a target output frequency, the driver will set the PLL and + divider to best approximate the desired output. + config COMMON_CLK_S2MPS11 tristate "Clock driver for S2MPS1X/S5M8767 MFD" depends on MFD_SEC_CORE @@ -96,7 +134,7 @@ config CLK_TWL6040 config COMMON_CLK_AXI_CLKGEN tristate "AXI clkgen driver" - depends on ARCH_ZYNQ || MICROBLAZE + depends on ARCH_ZYNQ || MICROBLAZE || COMPILE_TEST help ---help--- Support for the Analog Devices axi-clkgen pcore clock generator for Xilinx @@ -104,7 +142,7 @@ config COMMON_CLK_AXI_CLKGEN config CLK_QORIQ bool "Clock driver for Freescale QorIQ platforms" - depends on (PPC_E500MC || ARM) && OF + depends on (PPC_E500MC || ARM || ARM64 || COMPILE_TEST) && OF ---help--- This adds the clock driver support for Freescale QorIQ platforms using common clock framework. @@ -112,13 +150,13 @@ config CLK_QORIQ config COMMON_CLK_XGENE bool "Clock driver for APM XGene SoC" default y - depends on ARM64 + depends on ARM64 || COMPILE_TEST ---help--- Sypport for the APM X-Gene SoC reference, PLL, and device clocks. config COMMON_CLK_KEYSTONE tristate "Clock drivers for Keystone based SOCs" - depends on ARCH_KEYSTONE && OF + depends on (ARCH_KEYSTONE || COMPILE_TEST) && OF ---help--- Supports clock drivers for Keystone based SOCs. These SOCs have local a power sleep control module that gate the clock to the IPs and PLLs. @@ -150,11 +188,13 @@ config COMMON_CLK_CDCE706 ---help--- This driver supports TI CDCE706 programmable 3-PLL clock synthesizer. +source "drivers/clk/bcm/Kconfig" +source "drivers/clk/hisilicon/Kconfig" source "drivers/clk/qcom/Kconfig" endmenu -source "drivers/clk/bcm/Kconfig" source "drivers/clk/mvebu/Kconfig" source "drivers/clk/samsung/Kconfig" +source "drivers/clk/tegra/Kconfig" |