diff options
Diffstat (limited to 'kernel/arch/cris/arch-v32/mm/mmu.S')
| -rw-r--r-- | kernel/arch/cris/arch-v32/mm/mmu.S | 210 |
1 files changed, 210 insertions, 0 deletions
diff --git a/kernel/arch/cris/arch-v32/mm/mmu.S b/kernel/arch/cris/arch-v32/mm/mmu.S new file mode 100644 index 000000000..c0981044e --- /dev/null +++ b/kernel/arch/cris/arch-v32/mm/mmu.S @@ -0,0 +1,210 @@ +; WARNING : The refill handler has been modified, see below !!! + +/* + * Copyright (C) 2003 Axis Communications AB + * + * Authors: Mikael Starvik (starvik@axis.com) + * + * Code for the fault low-level handling routines. + * + */ + +#include <asm/page.h> +#include <asm/pgtable.h> + +; Save all register. Must save in same order as struct pt_regs. +.macro SAVE_ALL + subq 12, $sp + move $erp, [$sp] + subq 4, $sp + move $srp, [$sp] + subq 4, $sp + move $ccs, [$sp] + subq 4, $sp + move $spc, [$sp] + subq 4, $sp + move $mof, [$sp] + subq 4, $sp + move $srs, [$sp] + subq 4, $sp + move.d $acr, [$sp] + subq 14*4, $sp + movem $r13, [$sp] + subq 4, $sp + move.d $r10, [$sp] +.endm + +; Bus fault handler. Extracts relevant information and calls mm subsystem +; to handle the fault. +.macro MMU_BUS_FAULT_HANDLER handler, mmu, we, ex + .globl \handler + .type \handler,"function" +\handler: + SAVE_ALL + move \mmu, $srs ; Select MMU support register bank + move.d $sp, $r11 ; regs + moveq 1, $r12 ; protection fault + moveq \we, $r13 ; write exception? + orq \ex << 1, $r13 ; execute? + move $s3, $r10 ; rw_mm_cause + and.d ~8191, $r10 ; Get faulting page start address + + jsr do_page_fault + nop + ba ret_from_intr + nop + .size \handler, . - \handler +.endm + +; Refill handler. Three cases may occur: +; 1. PMD and PTE exists in mm subsystem but not in TLB +; 2. PMD exists but not PTE +; 3. PMD doesn't exist +; The code below handles case 1 and calls the mm subsystem for case 2 and 3. +; Do not touch this code without very good reasons and extensive testing. +; Note that the code is optimized to minimize stalls (makes the code harder +; to read). +; +; WARNING !!! +; Modified by Mikael Asker 060725: added a workaround for strange TLB +; behavior. If the same PTE is present in more than one set, the TLB +; doesn't recognize it and we get stuck in a loop of refill exceptions. +; The workaround detects such loops and exits them by flushing +; the TLB contents. The problem and workaround were verified +; in VCS by Mikael Starvik. +; +; Each page is 8 KB. Each PMD holds 8192/4 PTEs (each PTE is 4 bytes) so each +; PMD holds 16 MB of virtual memory. +; Bits 0-12 : Offset within a page +; Bits 13-23 : PTE offset within a PMD +; Bits 24-31 : PMD offset within the PGD + +.macro MMU_REFILL_HANDLER handler, mmu + .data +1: .dword 0 ; refill_count + ; == 0 <=> last_refill_cause is invalid +2: .dword 0 ; last_refill_cause + .text + .globl \handler + .type \handler, "function" +\handler: + subq 4, $sp +; (The pipeline stalls for one cycle; $sp used as address in the next cycle.) + move $srs, [$sp] + subq 4, $sp + move \mmu, $srs ; Select MMU support register bank + move.d $acr, [$sp] + subq 12, $sp + move.d 1b, $acr ; Point to refill_count + movem $r2, [$sp] + + test.d [$acr] ; refill_count == 0 ? + beq 5f ; yes, last_refill_cause is invalid + move.d $acr, $r1 + + ; last_refill_cause is valid, investigate cause + addq 4, $r1 ; Point to last_refill_cause + move $s3, $r0 ; Get rw_mm_cause + move.d [$r1], $r2 ; Get last_refill_cause + cmp.d $r0, $r2 ; rw_mm_cause == last_refill_cause ? + beq 6f ; yes, increment count + moveq 1, $r2 + + ; rw_mm_cause != last_refill_cause + move.d $r2, [$acr] ; refill_count = 1 + move.d $r0, [$r1] ; last_refill_cause = rw_mm_cause + +3: ; Probably not in a loop, continue normal processing + move.d current_pgd, $acr ; PGD + ; Look up PMD in PGD + lsrq 24, $r0 ; Get PMD index into PGD (bit 24-31) + move.d [$acr], $acr ; PGD for the current process + addi $r0.d, $acr, $acr + move $s3, $r0 ; rw_mm_cause + move.d [$acr], $acr ; Get PMD + beq 8f + ; Look up PTE in PMD + lsrq PAGE_SHIFT, $r0 + and.w PAGE_MASK, $acr ; Remove PMD flags + and.d 0x7ff, $r0 ; Get PTE index into PMD (bit 13-23) + addi $r0.d, $acr, $acr + move.d [$acr], $acr ; Get PTE + beq 9f + movem [$sp], $r2 ; Restore r0-r2 in delay slot + addq 12, $sp + ; Store in TLB + move $acr, $s5 +4: ; Return + move.d [$sp+], $acr + move [$sp], $srs + addq 4, $sp + rete + rfe + +5: ; last_refill_cause is invalid + moveq 1, $r2 + addq 4, $r1 ; Point to last_refill_cause + move.d $r2, [$acr] ; refill_count = 1 + move $s3, $r0 ; Get rw_mm_cause + ba 3b ; Continue normal processing + move.d $r0,[$r1] ; last_refill_cause = rw_mm_cause + +6: ; rw_mm_cause == last_refill_cause + move.d [$acr], $r2 ; Get refill_count + cmpq 4, $r2 ; refill_count > 4 ? + bhi 7f ; yes + addq 1, $r2 ; refill_count++ + ba 3b ; Continue normal processing + move.d $r2, [$acr] + +7: ; refill_count > 4, error + move.d $acr, $r0 ; Save pointer to refill_count + clear.d [$r0] ; refill_count = 0 + + ;; rewind the short stack + movem [$sp], $r2 ; Restore r0-r2 + addq 12, $sp + move.d [$sp+], $acr + move [$sp], $srs + addq 4, $sp + ;; Keep it simple (slow), save all the regs. + SAVE_ALL + jsr __flush_tlb_all + nop + ba ret_from_intr ; Return + nop + +8: ; PMD missing, let the mm subsystem fix it up. + movem [$sp], $r2 ; Restore r0-r2 +9: ; PTE missing, let the mm subsystem fix it up. + addq 12, $sp + move.d [$sp+], $acr + move [$sp], $srs + addq 4, $sp + SAVE_ALL + move \mmu, $srs + move.d $sp, $r11 ; regs + clear.d $r12 ; Not a protection fault + move.w PAGE_MASK, $acr + move $s3, $r10 ; rw_mm_cause + btstq 9, $r10 ; Check if write access + smi $r13 + and.w PAGE_MASK, $r10 ; Get VPN (virtual address) + jsr do_page_fault + and.w $acr, $r10 + ; Return + ba ret_from_intr + nop + .size \handler, . - \handler +.endm + + ; This is the MMU bus fault handlers. + +MMU_REFILL_HANDLER i_mmu_refill, 1 +MMU_BUS_FAULT_HANDLER i_mmu_invalid, 1, 0, 0 +MMU_BUS_FAULT_HANDLER i_mmu_access, 1, 0, 0 +MMU_BUS_FAULT_HANDLER i_mmu_execute, 1, 0, 1 +MMU_REFILL_HANDLER d_mmu_refill, 2 +MMU_BUS_FAULT_HANDLER d_mmu_invalid, 2, 0, 0 +MMU_BUS_FAULT_HANDLER d_mmu_access, 2, 0, 0 +MMU_BUS_FAULT_HANDLER d_mmu_write, 2, 1, 0 |