diff options
Diffstat (limited to 'kernel/Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt')
| -rw-r--r-- | kernel/Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt | 57 |
1 files changed, 57 insertions, 0 deletions
diff --git a/kernel/Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt b/kernel/Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt new file mode 100644 index 000000000..53579197e --- /dev/null +++ b/kernel/Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt @@ -0,0 +1,57 @@ +* Universal Flash Storage (UFS) Host Controller + +UFSHC nodes are defined to describe on-chip UFS host controllers. +Each UFS controller instance should have its own node. + +Required properties: +- compatible : compatible list, contains "jedec,ufs-1.1" +- interrupts : <interrupt mapping for UFS host controller IRQ> +- reg : <registers mapping> + +Optional properties: +- vdd-hba-supply : phandle to UFS host controller supply regulator node +- vcc-supply : phandle to VCC supply regulator node +- vccq-supply : phandle to VCCQ supply regulator node +- vccq2-supply : phandle to VCCQ2 supply regulator node +- vcc-supply-1p8 : For embedded UFS devices, valid VCC range is 1.7-1.95V + or 2.7-3.6V. This boolean property when set, specifies + to use low voltage range of 1.7-1.95V. Note for external + UFS cards this property is invalid and valid VCC range is + always 2.7-3.6V. +- vcc-max-microamp : specifies max. load that can be drawn from vcc supply +- vccq-max-microamp : specifies max. load that can be drawn from vccq supply +- vccq2-max-microamp : specifies max. load that can be drawn from vccq2 supply +- <name>-fixed-regulator : boolean property specifying that <name>-supply is a fixed regulator + +- clocks : List of phandle and clock specifier pairs +- clock-names : List of clock input name strings sorted in the same + order as the clocks property. +- freq-table-hz : Array of <min max> operating frequencies stored in the same + order as the clocks property. If this property is not + defined or a value in the array is "0" then it is assumed + that the frequency is set by the parent clock or a + fixed rate clock source. + +Note: If above properties are not defined it can be assumed that the supply +regulators or clocks are always on. + +Example: + ufshc@0xfc598000 { + compatible = "jedec,ufs-1.1"; + reg = <0xfc598000 0x800>; + interrupts = <0 28 0>; + + vdd-hba-supply = <&xxx_reg0>; + vdd-hba-fixed-regulator; + vcc-supply = <&xxx_reg1>; + vcc-supply-1p8; + vccq-supply = <&xxx_reg2>; + vccq2-supply = <&xxx_reg3>; + vcc-max-microamp = 500000; + vccq-max-microamp = 200000; + vccq2-max-microamp = 200000; + + clocks = <&core 0>, <&ref 0>, <&iface 0>; + clock-names = "core_clk", "ref_clk", "iface_clk"; + freq-table-hz = <100000000 200000000>, <0 0>, <0 0>; + }; |