Add qemu 2.4.0

Change-Id: Ic99cbad4b61f8b127b7dc74d04576c0bcbaaf4f5
Signed-off-by: Yang Zhang <yang.z.zhang@intel.com>

1 files changed, 25 insertions, 0 deletions

diff --git a/qemu/roms/u-boot/doc/device-tree-bindings/usb/tegra-usb.txt b/qemu/roms/u-boot/doc/device-tree-bindings/usb/tegra-usb.txt
new file mode 100644
index 000000000..5282d44ac
--- /dev/null
+++ b/qemu/roms/u-boot/doc/device-tree-bindings/usb/tegra-usb.txt
@@ -0,0 +1,25 @@
+Tegra SOC USB controllers
+
+The device node for a USB controller that is part of a Tegra
+SOC is as described in the document "Open Firmware Recommended
+Practice : Universal Serial Bus" with the following modifications
+and additions :
+
+Required properties :
+ - compatible : Should be "nvidia,tegra20-ehci" for USB controllers
+   used in host mode.
+ - phy_type : Should be one of "ulpi" or "utmi".
+ - nvidia,vbus-gpio : If present, specifies a gpio that needs to be
+   activated for the bus to be powered.
+
+Optional properties:
+  - dr_mode : dual role mode. Indicates the working mode for
+    nvidia,tegra20-ehci compatible controllers.  Can be "host", "peripheral",
+    or "otg".  Default to "host" if not defined for backward compatibility.
+      host means this is a host controller
+      peripheral means it is device controller
+      otg means it can operate as either ("on the go")
+  - nvidia,has-legacy-mode : boolean indicates whether this controller can
+    operate in legacy mode (as APX 2500 / 2600). In legacy mode some
+    registers are accessed through the APB_MISC base address instead of
+    the USB controller.