These changes are the raw update to linux-4.4.6-rt14. Kernel sources

are taken from kernel.org, and rt patch from the rt wiki download page.

During the rebasing, the following patch collided:

Force tick interrupt and get rid of softirq magic(I70131fb85).

Collisions have been removed because its logic was found on the
source already.

Change-Id: I7f57a4081d9deaa0d9ccfc41a6c8daccdee3b769
Signed-off-by: José Pekkarinen <jose.pekkarinen@nokia.com>

1 files changed, 67 insertions, 10 deletions

diff --git a/kernel/drivers/input/serio/i8042.c b/kernel/drivers/input/serio/i8042.c
index cb5ece77f..454195709 100644
--- a/kernel/drivers/input/serio/i8042.c
+++ b/kernel/drivers/input/serio/i8042.c
@@ -24,6 +24,7 @@
 #include <linux/platform_device.h>
 #include <linux/i8042.h>
 #include <linux/slab.h>
+#include <linux/suspend.h>
 
 #include <asm/io.h>
 
@@ -88,6 +89,10 @@ MODULE_PARM_DESC(nopnp, "Do not use PNP to detect controller settings");
 static bool i8042_debug;
 module_param_named(debug, i8042_debug, bool, 0600);
 MODULE_PARM_DESC(debug, "Turn i8042 debugging mode on and off");
+
+static bool i8042_unmask_kbd_data;
+module_param_named(unmask_kbd_data, i8042_unmask_kbd_data, bool, 0600);
+MODULE_PARM_DESC(unmask_kbd_data, "Unconditional enable (may reveal sensitive data) of normally sanitize-filtered kbd data traffic debug log [pre-condition: i8042.debug=1 enabled]");
 #endif
 
 static bool i8042_bypass_aux_irq_test;
@@ -116,6 +121,7 @@ struct i8042_port {
 	struct serio *serio;
 	int irq;
 	bool exists;
+	bool driver_bound;
 	signed char mux;
 };
 
@@ -133,6 +139,7 @@ static bool i8042_kbd_irq_registered;
 static bool i8042_aux_irq_registered;
 static unsigned char i8042_suppress_kbd_ack;
 static struct platform_device *i8042_platform_device;
+static struct notifier_block i8042_kbd_bind_notifier_block;
 
 static irqreturn_t i8042_interrupt(int irq, void *dev_id);
 static bool (*i8042_platform_filter)(unsigned char data, unsigned char str,
@@ -528,10 +535,10 @@ static irqreturn_t i8042_interrupt(int irq, void *dev_id)
 	port = &i8042_ports[port_no];
 	serio = port->exists ? port->serio : NULL;
 
-	dbg("%02x <- i8042 (interrupt, %d, %d%s%s)\n",
-	    data, port_no, irq,
-	    dfl & SERIO_PARITY ? ", bad parity" : "",
-	    dfl & SERIO_TIMEOUT ? ", timeout" : "");
+	filter_dbg(port->driver_bound, data, "<- i8042 (interrupt, %d, %d%s%s)\n",
+		   port_no, irq,
+		   dfl & SERIO_PARITY ? ", bad parity" : "",
+		   dfl & SERIO_TIMEOUT ? ", timeout" : "");
 
 	filtered = i8042_filter(data, str, serio);
 
@@ -871,7 +878,7 @@ static int __init i8042_check_aux(void)
 static int i8042_controller_check(void)
 {
 	if (i8042_flush()) {
-		pr_err("No controller found\n");
+		pr_info("No controller found\n");
 		return -ENODEV;
 	}
 
@@ -1164,7 +1171,8 @@ static int i8042_pm_suspend(struct device *dev)
 {
 	int i;
 
-	i8042_controller_reset(true);
+	if (pm_suspend_via_firmware())
+		i8042_controller_reset(true);
 
 	/* Set up serio interrupts for system wakeup. */
 	for (i = 0; i < I8042_NUM_PORTS; i++) {
@@ -1177,8 +1185,17 @@ static int i8042_pm_suspend(struct device *dev)
 	return 0;
 }
 
+static int i8042_pm_resume_noirq(struct device *dev)
+{
+	if (!pm_resume_via_firmware())
+		i8042_interrupt(0, NULL);
+
+	return 0;
+}
+
 static int i8042_pm_resume(struct device *dev)
 {
+	bool force_reset;
 	int i;
 
 	for (i = 0; i < I8042_NUM_PORTS; i++) {
@@ -1189,11 +1206,21 @@ static int i8042_pm_resume(struct device *dev)
 	}
 
 	/*
-	 * On resume from S2R we always try to reset the controller
-	 * to bring it in a sane state. (In case of S2D we expect
-	 * BIOS to reset the controller for us.)
+	 * If platform firmware was not going to be involved in suspend, we did
+	 * not restore the controller state to whatever it had been at boot
+	 * time, so we do not need to do anything.
 	 */
-	return i8042_controller_resume(true);
+	if (!pm_suspend_via_firmware())
+		return 0;
+
+	/*
+	 * We only need to reset the controller if we are resuming after handing
+	 * off control to the platform firmware, otherwise we can simply restore
+	 * the mode.
+	 */
+	force_reset = pm_resume_via_firmware();
+
+	return i8042_controller_resume(force_reset);
 }
 
 static int i8042_pm_thaw(struct device *dev)
@@ -1217,6 +1244,7 @@ static int i8042_pm_restore(struct device *dev)
 
 static const struct dev_pm_ops i8042_pm_ops = {
 	.suspend	= i8042_pm_suspend,
+	.resume_noirq	= i8042_pm_resume_noirq,
 	.resume		= i8042_pm_resume,
 	.thaw		= i8042_pm_thaw,
 	.poweroff	= i8042_pm_reset,
@@ -1438,6 +1466,29 @@ static int __init i8042_setup_kbd(void)
 	return error;
 }
 
+static int i8042_kbd_bind_notifier(struct notifier_block *nb,
+				   unsigned long action, void *data)
+{
+	struct device *dev = data;
+	struct serio *serio = to_serio_port(dev);
+	struct i8042_port *port = serio->port_data;
+
+	if (serio != i8042_ports[I8042_KBD_PORT_NO].serio)
+		return 0;
+
+	switch (action) {
+	case BUS_NOTIFY_BOUND_DRIVER:
+		port->driver_bound = true;
+		break;
+
+	case BUS_NOTIFY_UNBIND_DRIVER:
+		port->driver_bound = false;
+		break;
+	}
+
+	return 0;
+}
+
 static int __init i8042_probe(struct platform_device *dev)
 {
 	int error;
@@ -1507,6 +1558,10 @@ static struct platform_driver i8042_driver = {
 	.shutdown	= i8042_shutdown,
 };
 
+static struct notifier_block i8042_kbd_bind_notifier_block = {
+	.notifier_call = i8042_kbd_bind_notifier,
+};
+
 static int __init i8042_init(void)
 {
 	struct platform_device *pdev;
@@ -1528,6 +1583,7 @@ static int __init i8042_init(void)
 		goto err_platform_exit;
 	}
 
+	bus_register_notifier(&serio_bus, &i8042_kbd_bind_notifier_block);
 	panic_blink = i8042_panic_blink;
 
 	return 0;
@@ -1543,6 +1599,7 @@ static void __exit i8042_exit(void)
 	platform_driver_unregister(&i8042_driver);
 	i8042_platform_exit();
 
+	bus_unregister_notifier(&serio_bus, &i8042_kbd_bind_notifier_block);
 	panic_blink = NULL;
 }