These changes are the raw update to linux-4.4.6-rt14. Kernel sources

are taken from kernel.org, and rt patch from the rt wiki download page.

During the rebasing, the following patch collided:

Force tick interrupt and get rid of softirq magic(I70131fb85).

Collisions have been removed because its logic was found on the
source already.

Change-Id: I7f57a4081d9deaa0d9ccfc41a6c8daccdee3b769
Signed-off-by: José Pekkarinen <jose.pekkarinen@nokia.com>

1 files changed, 50 insertions, 13 deletions

diff --git a/kernel/arch/mips/ralink/mt7620.c b/kernel/arch/mips/ralink/mt7620.c
index 2ea5ff6dc..dfb04fced 100644
--- a/kernel/arch/mips/ralink/mt7620.c
+++ b/kernel/arch/mips/ralink/mt7620.c
@@ -37,8 +37,17 @@
 #define PMU1_CFG		0x8C
 #define DIG_SW_SEL		BIT(25)
 
-/* is this a MT7620 or a MT7628 */
-enum mt762x_soc_type mt762x_soc;
+/* clock scaling */
+#define CLKCFG_FDIV_MASK	0x1f00
+#define CLKCFG_FDIV_USB_VAL	0x0300
+#define CLKCFG_FFRAC_MASK	0x001f
+#define CLKCFG_FFRAC_USB_VAL	0x0003
+
+/* EFUSE bits */
+#define EFUSE_MT7688		0x100000
+
+/* DRAM type bit */
+#define DRAM_TYPE_MT7628_MASK	0x1
 
 /* does the board have sdram or ddram */
 static int dram_type;
@@ -227,6 +236,12 @@ static struct rt2880_pmx_group mt7628an_pinmux_data[] = {
 	{ 0 }
 };
 
+static inline int is_mt76x8(void)
+{
+	return ralink_soc == MT762X_SOC_MT7628AN ||
+	       ralink_soc == MT762X_SOC_MT7688;
+}
+
 static __init u32
 mt7620_calc_rate(u32 ref_rate, u32 mul, u32 div)
 {
@@ -381,7 +396,7 @@ void __init ralink_clk_init(void)
 #define RINT(x)		((x) / 1000000)
 #define RFRAC(x)	(((x) / 1000) % 1000)
 
-	if (mt762x_soc == MT762X_SOC_MT7628AN) {
+	if (is_mt76x8()) {
 		if (xtal_rate == MHZ(40))
 			cpu_rate = MHZ(580);
 		else
@@ -423,6 +438,20 @@ void __init ralink_clk_init(void)
 	ralink_clk_add("10000b00.spi", sys_rate);
 	ralink_clk_add("10000c00.uartlite", periph_rate);
 	ralink_clk_add("10180000.wmac", xtal_rate);
+
+	if (IS_ENABLED(CONFIG_USB) && is_mt76x8()) {
+		/*
+		 * When the CPU goes into sleep mode, the BUS clock will be
+		 * too low for USB to function properly. Adjust the busses
+		 * fractional divider to fix this
+		 */
+		u32 val = rt_sysc_r32(SYSC_REG_CPU_SYS_CLKCFG);
+
+		val &= ~(CLKCFG_FDIV_MASK | CLKCFG_FFRAC_MASK);
+		val |= CLKCFG_FDIV_USB_VAL | CLKCFG_FFRAC_USB_VAL;
+
+		rt_sysc_w32(val, SYSC_REG_CPU_SYS_CLKCFG);
+	}
 }
 
 void __init ralink_of_remap(void)
@@ -499,20 +528,24 @@ void prom_soc_init(struct ralink_soc_info *soc_info)
 
 	if (n0 == MT7620_CHIP_NAME0 && n1 == MT7620_CHIP_NAME1) {
 		if (bga) {
-			mt762x_soc = MT762X_SOC_MT7620A;
+			ralink_soc = MT762X_SOC_MT7620A;
 			name = "MT7620A";
 			soc_info->compatible = "ralink,mt7620a-soc";
 		} else {
-			mt762x_soc = MT762X_SOC_MT7620N;
+			ralink_soc = MT762X_SOC_MT7620N;
 			name = "MT7620N";
 			soc_info->compatible = "ralink,mt7620n-soc";
-#ifdef CONFIG_PCI
-			panic("mt7620n is only supported for non pci kernels");
-#endif
 		}
 	} else if (n0 == MT7620_CHIP_NAME0 && n1 == MT7628_CHIP_NAME1) {
-		mt762x_soc = MT762X_SOC_MT7628AN;
-		name = "MT7628AN";
+		u32 efuse = __raw_readl(sysc + SYSC_REG_EFUSE_CFG);
+
+		if (efuse & EFUSE_MT7688) {
+			ralink_soc = MT762X_SOC_MT7688;
+			name = "MT7688";
+		} else {
+			ralink_soc = MT762X_SOC_MT7628AN;
+			name = "MT7628AN";
+		}
 		soc_info->compatible = "ralink,mt7628an-soc";
 	} else {
 		panic("mt762x: unknown SoC, n0:%08x n1:%08x\n", n0, n1);
@@ -525,10 +558,14 @@ void prom_soc_init(struct ralink_soc_info *soc_info)
 		(rev & CHIP_REV_ECO_MASK));
 
 	cfg0 = __raw_readl(sysc + SYSC_REG_SYSTEM_CONFIG0);
-	dram_type = (cfg0 >> SYSCFG0_DRAM_TYPE_SHIFT) & SYSCFG0_DRAM_TYPE_MASK;
+	if (is_mt76x8())
+		dram_type = cfg0 & DRAM_TYPE_MT7628_MASK;
+	else
+		dram_type = (cfg0 >> SYSCFG0_DRAM_TYPE_SHIFT) &
+			    SYSCFG0_DRAM_TYPE_MASK;
 
 	soc_info->mem_base = MT7620_DRAM_BASE;
-	if (mt762x_soc == MT762X_SOC_MT7628AN)
+	if (is_mt76x8())
 		mt7628_dram_init(soc_info);
 	else
 		mt7620_dram_init(soc_info);
@@ -541,7 +578,7 @@ void prom_soc_init(struct ralink_soc_info *soc_info)
 	pr_info("Digital PMU set to %s control\n",
 		(pmu1 & DIG_SW_SEL) ? ("sw") : ("hw"));
 
-	if (mt762x_soc == MT762X_SOC_MT7628AN)
+	if (is_mt76x8())
 		rt2880_pinmux_data = mt7628an_pinmux_data;
 	else
 		rt2880_pinmux_data = mt7620a_pinmux_data;