diff options
| author |   José Pekkarinen <jose.pekkarinen@nokia.com> | 2016-04-11 10:41:07 +0300 |
|---|---|---|
| committer | José Pekkarinen <jose.pekkarinen@nokia.com> | 2016-04-13 08:17:18 +0300 |
| commit | e09b41010ba33a20a87472ee821fa407a5b8da36 (patch) | |
| tree | d10dc367189862e7ca5c592f033dc3726e1df4e3 /kernel/Documentation/devicetree/bindings/usb/msm-hsusb.txt | |
| parent | f93b97fd65072de626c074dbe099a1fff05ce060 (diff) | |
These changes are the raw update to linux-4.4.6-rt14. Kernel sources
are taken from kernel.org, and rt patch from the rt wiki download page.
During the rebasing, the following patch collided:
Force tick interrupt and get rid of softirq magic(I70131fb85).
Collisions have been removed because its logic was found on the
source already.
Change-Id: I7f57a4081d9deaa0d9ccfc41a6c8daccdee3b769
Signed-off-by: José Pekkarinen <jose.pekkarinen@nokia.com>
Diffstat (limited to 'kernel/Documentation/devicetree/bindings/usb/msm-hsusb.txt')
| -rw-r--r-- | kernel/Documentation/devicetree/bindings/usb/msm-hsusb.txt | 15 |
1 files changed, 15 insertions, 0 deletions
diff --git a/kernel/Documentation/devicetree/bindings/usb/msm-hsusb.txt b/kernel/Documentation/devicetree/bindings/usb/msm-hsusb.txt index 2826f2af5..8654a3ec2 100644 --- a/kernel/Documentation/devicetree/bindings/usb/msm-hsusb.txt +++ b/kernel/Documentation/devicetree/bindings/usb/msm-hsusb.txt @@ -52,6 +52,10 @@ Required properties: Optional properties: - dr_mode: One of "host", "peripheral" or "otg". Defaults to "otg" +- switch-gpio: A phandle + gpio-specifier pair. Some boards are using Dual + SPDT USB Switch, witch is cotrolled by GPIO to de/multiplex + D+/D- USB lines between connectors. + - qcom,phy-init-sequence: PHY configuration sequence values. This is related to Device Mode Eye Diagram test. Start address at which these values will be written is ULPI_EXT_VENDOR_SPECIFIC. Value of -1 is reserved as @@ -69,6 +73,17 @@ Optional properties: (no, min, max) where each value represents either a voltage in microvolts or a value corresponding to voltage corner. +- qcom,manual-pullup: If present, vbus is not routed to USB controller/phy + and controller driver therefore enables pull-up explicitly + before starting controller using usbcmd run/stop bit. + +- extcon: phandles to external connector devices. First phandle + should point to external connector, which provide "USB" + cable events, the second should point to external connector + device, which provide "USB-HOST" cable events. If one of + the external connector devices is not required empty <0> + phandle should be specified. + Example HSUSB OTG controller device node: usb@f9a55000 { |