These changes are the raw update to linux-4.4.6-rt14. Kernel sources

are taken from kernel.org, and rt patch from the rt wiki download page.

During the rebasing, the following patch collided:

Force tick interrupt and get rid of softirq magic(I70131fb85).

Collisions have been removed because its logic was found on the
source already.

Change-Id: I7f57a4081d9deaa0d9ccfc41a6c8daccdee3b769
Signed-off-by: José Pekkarinen <jose.pekkarinen@nokia.com>

1 files changed, 0 insertions, 66 deletions

diff --git a/kernel/Documentation/devicetree/bindings/drm/tilcdc/panel.txt b/kernel/Documentation/devicetree/bindings/drm/tilcdc/panel.txt
deleted file mode 100644
index 4ab9e2300..000000000
--- a/kernel/Documentation/devicetree/bindings/drm/tilcdc/panel.txt
+++ /dev/null
@@ -1,66 +0,0 @@
-Device-Tree bindings for tilcdc DRM generic panel output driver
-
-Required properties:
- - compatible: value should be "ti,tilcdc,panel".
- - panel-info: configuration info to configure LCDC correctly for the panel
-   - ac-bias: AC Bias Pin Frequency
-   - ac-bias-intrpt: AC Bias Pin Transitions per Interrupt
-   - dma-burst-sz: DMA burst size
-   - bpp: Bits per pixel
-   - fdd: FIFO DMA Request Delay
-   - sync-edge: Horizontal and Vertical Sync Edge: 0=rising 1=falling
-   - sync-ctrl: Horizontal and Vertical Sync: Control: 0=ignore
-   - raster-order: Raster Data Order Select: 1=Most-to-least 0=Least-to-most
-   - fifo-th: DMA FIFO threshold
- - display-timings: typical videomode of lcd panel.  Multiple video modes
-   can be listed if the panel supports multiple timings, but the 'native-mode'
-   should be the preferred/default resolution.  Refer to
-   Documentation/devicetree/bindings/video/display-timing.txt for display
-   timing binding details.
-
-Optional properties:
-- backlight: phandle of the backlight device attached to the panel
-- enable-gpios: GPIO pin to enable or disable the panel
-
-Recommended properties:
- - pinctrl-names, pinctrl-0: the pincontrol settings to configure
-   muxing properly for pins that connect to TFP410 device
-
-Example:
-
-	/* Settings for CDTech_S035Q01 / LCD3 cape: */
-	lcd3 {
-		compatible = "ti,tilcdc,panel";
-		pinctrl-names = "default";
-		pinctrl-0 = <&bone_lcd3_cape_lcd_pins>;
-		backlight = <&backlight>;
-		enable-gpios = <&gpio3 19 0>;
-
-		panel-info {
-			ac-bias           = <255>;
-			ac-bias-intrpt    = <0>;
-			dma-burst-sz      = <16>;
-			bpp               = <16>;
-			fdd               = <0x80>;
-			sync-edge         = <0>;
-			sync-ctrl         = <1>;
-			raster-order      = <0>;
-			fifo-th           = <0>;
-		};
-		display-timings {
-			native-mode = <&timing0>;
-			timing0: 320x240 {
-				hactive         = <320>;
-				vactive         = <240>;
-				hback-porch     = <21>;
-				hfront-porch    = <58>;
-				hsync-len       = <47>;
-				vback-porch     = <11>;
-				vfront-porch    = <23>;
-				vsync-len       = <2>;
-				clock-frequency = <8000000>;
-				hsync-active    = <0>;
-				vsync-active    = <0>;
-			};
-		};
-	};