| Age | Commit message (Collapse) | Author | Files | Lines |
|---|
|
The method get_node_state has been added to the the IpmiAdapter class.
In addition, now the power on/off methods will try several times to
perform their IPMI command before giving up, instead of bailing out at
the first error.
After the power on/off command is completed, the method will wait until
the node is in the desired state.
NOTE: a command could potentially take several minutes if the defaults
are used; each IPMI command can take up to 1 minute, and there can be 3
commands issued per operation, one of them may be retried 20 times with
the current defaults. Ideally we would use eventlet or something similar
to allow each command a limited time to execute, instead:
with eventlet.timeout.Timeout(seconds) as t:
power_on/off_command
Signed-off-by: Josep Puigdemont <josep.puigdemont@enea.com>
|
|
Sometimes the IPMI lanplus protocol listens on a non-standard
remote port, e.g. when target nodes are interfaced through a
fake IPMI BMC application that listens on multiple ports on the
same IP address.
Therefore, allow setting IPMI port in the DHA using a new
property named `ipmiPort`, and pass it along to `ipmitool` when set.
CHANGE: get_access_info now also supports specifying the IPMI
port to use with `ipmitool` by configuring the `ipmiPort`
property in the DHA.
hp_adapter.py: updated `get_access_info` return signature with
the new (unused there) `ipmiport`.
Change-Id: I620176bd7f466aa460518cf12d15ccbe86a22560
Signed-off-by: Alexandru Avadanii <Alexandru.Avadanii@enea.com>
|
|
Restructure of the directory layout due to move of Fuel into it's own repo
JIRA: FUEL-85
Change-Id: I3647e1992a508f29dce06a5d6c790725c527f6f5
Signed-off-by: Jonas Bjurel <jonas.bjurel@ericsson.com>
|
Josep Puigdemont
Alexandru Avadanii
Jonas Bjurel