summaryrefslogtreecommitdiffstats
path: root/deploy/dha_adapters/ipmi_adapter.py
AgeCommit message (Collapse)AuthorFilesLines
2016-06-15ipmi_adapter: simplify, retry if command failsJosep Puigdemont1-59/+42
The method get_node_state has been added to the the IpmiAdapter class. In addition, now the power on/off methods will try several times to perform their IPMI command before giving up, instead of bailing out at the first error. After the power on/off command is completed, the method will wait until the node is in the desired state. NOTE: a command could potentially take several minutes if the defaults are used; each IPMI command can take up to 1 minute, and there can be 3 commands issued per operation, one of them may be retried 20 times with the current defaults. Ideally we would use eventlet or something similar to allow each command a limited time to execute, instead: with eventlet.timeout.Timeout(seconds) as t: power_on/off_command Signed-off-by: Josep Puigdemont <josep.puigdemont@enea.com>
2016-06-15deploy: ipmi adapter: Add <port> config support.Alexandru Avadanii1-2/+5
Sometimes the IPMI lanplus protocol listens on a non-standard remote port, e.g. when target nodes are interfaced through a fake IPMI BMC application that listens on multiple ports on the same IP address. Therefore, allow setting IPMI port in the DHA using a new property named `ipmiPort`, and pass it along to `ipmitool` when set. CHANGE: get_access_info now also supports specifying the IPMI port to use with `ipmitool` by configuring the `ipmiPort` property in the DHA. hp_adapter.py: updated `get_access_info` return signature with the new (unused there) `ipmiport`. Change-Id: I620176bd7f466aa460518cf12d15ccbe86a22560 Signed-off-by: Alexandru Avadanii <Alexandru.Avadanii@enea.com>
2015-11-27Restructcture of the directory layoutJonas Bjurel1-0/+119
Restructure of the directory layout due to move of Fuel into it's own repo JIRA: FUEL-85 Change-Id: I3647e1992a508f29dce06a5d6c790725c527f6f5 Signed-off-by: Jonas Bjurel <jonas.bjurel@ericsson.com>