1 files changed, 0 insertions, 79 deletions
diff --git a/docs/installation-instructions/requirements.rst b/docs/installation-instructions/requirements.rst
deleted file mode 100644
index d54d584b..00000000
--- a/docs/installation-instructions/requirements.rst
+++ /dev/null
@@ -1,79 +0,0 @@
-Setup Requirements
-==================
-
-Jumphost Requirements
----------------------
-
-The Jumphost requirements are outlined below:
-
-1.     CentOS 7 (from ISO or self-installed).
-
-2.     Root access.
-
-3.     libvirt virtualization support.
-
-4.     minimum 1 networks and maximum 5 networks, multiple NIC and/or VLAN
-       combinations are supported.  This is virtualized for a VM deployment.
-
-5.     The Colorado Apex RPMs and their dependencies.
-
-6.     16 GB of RAM for a bare metal deployment, 64 GB of RAM for a VM
-       deployment.
-
-Network Requirements
---------------------
-
-Network requirements include:
-
-1.     No DHCP or TFTP server running on networks used by OPNFV.
-
-2.     1-5 separate networks with connectivity between Jumphost and nodes.
-
-       -  Control Plane (Provisioning)
-
-       -  Private Tenant-Networking Network*
-
-       -  External Network
-
-       -  Storage Network*
-
-       -  Internal API Network* (required for IPv6 \*\*)
-
-3.     Lights out OOB network access from Jumphost with IPMI node enabled
-       (bare metal deployment only).
-
-4.     External network is a routable network from outside the cloud,
-       deployment. The External network is where public internet access would
-       reside if available.
-
-\* *These networks can be combined with each other or all combined on the
-    Control Plane network.*
-\* *Non-External networks will be consolidated to the Control Plane network
-    if not specifically configured.*
-\*\* *Internal API network, by default, is collapsed with provisioning in IPv4
-     deployments, this is not possible with the current lack of PXE boot
-     support and therefore the API network is required to be its own
-     network in an IPv6 deployment.*
-
-Bare Metal Node Requirements
-----------------------------
-
-Bare metal nodes require:
-
-1.     IPMI enabled on OOB interface for power control.
-
-2.     BIOS boot priority should be PXE first then local hard disk.
-
-3.     BIOS PXE interface should include Control Plane network mentioned above.
-
-Execution Requirements (Bare Metal Only)
-----------------------------------------
-
-In order to execute a deployment, one must gather the following information:
-
-1.     IPMI IP addresses for the nodes.
-
-2.     IPMI login information for the nodes (user/pass).
-
-3.     MAC address of Control Plane / Provisioning interfaces of the overcloud
-       nodes.