Doc updates for MS6

Updated the docs structure according to directives and MS6

Change-Id: I36e92cbc58328528ebb91ff4f54ee701f5477443
Signed-off-by: Sofia Wallin <sofia.wallin@ericsson.com>

1 files changed, 0 insertions, 69 deletions

diff --git a/docs/installationprocedure/virtualinstall.rst b/docs/installationprocedure/virtualinstall.rst
deleted file mode 100644
index 5da2ee3c..00000000
--- a/docs/installationprocedure/virtualinstall.rst
+++ /dev/null
@@ -1,69 +0,0 @@
-Installation High-Level Overview - Virtual Deployment
-=====================================================
-
-The VM nodes deployment operates almost the same way as the bare metal
-deployment with a few differences.  ``opnfv-deploy`` still deploys an
-undercloud VM. In addition to the undercloud VM a collection of VMs
-(3 control nodes + 2 compute for an HA deployment or 1 control node and 1
-or more compute nodes for a non-HA Deployment) will be defined for the target
-OPNFV deployment.  The part of the toolchain that executes IPMI power
-instructions calls into libvirt instead of the IPMI interfaces on baremetal
-servers to operate the power managment.  These VMs are then provisioned with
-the same disk images and configuration that baremetal would be. To Triple-O
-these nodes look like they have just built and registered the same way as bare
-metal nodes, the main difference is the use of a libvirt driver for the power
-management.  Finally, the default network_settings file will deploy without
-modification.  Customizations are welcome but not needed if a generic set of
-network_settings are acceptable.
-
-Installation Guide - Virtual Deployment
-=======================================
-
-This section goes step-by-step on how to correctly install and provision the
-OPNFV target system to VM nodes.
-
-Install Jumphost
-----------------
-
-Follow the instructions in the `Install Bare Metal Jumphost`_ section.
-
-Running ``opnfv-deploy``
-------------------------
-
-You are now ready to deploy OPNFV!
-``opnfv-deploy`` has virtual deployment capability that includes all of
-the configuration nessesary to deploy OPNFV with no modifications.
-
-If no modifications are made to the included configurations the target
-environment will deploy with the following architecture:
-
-    - 1 undercloud VM
-
-    - The option of 3 control and 2 or more compute VMs (HA Deploy / default)
-      or 1 control and 1 or more compute VM (Non-HA deploy / pass -n)
-
-    - 1-5 networks: provisioning, private tenant networking, external, storage
-      and internal API. The API, storage and tenant networking networks can be
-      collapsed onto the provisioning network.
-
-Follow the steps below to execute:
-
-1.  ``sudo opnfv-deploy -v [ --virtual-computes n ]
-    [ --virtual-cpus n ] [ --virtual-ram n ]
-    -n network_settings.yaml -d deploy_settings.yaml``
-
-2.  It will take approximately 45 minutes to an hour to stand up undercloud,
-    define the target virtual machines, configure the deployment and execute
-    the deployment.  You will notice different outputs in your shell.
-
-3.  When the deployment is complete the IP for the undercloud and a url for the
-    OpenStack dashboard will be displayed
-
-Verifying the Setup - VMs
--------------------------
-
-To verify the set you can follow the instructions in the `Verifying the Setup`_
-section.
-
-.. _`Install Bare Metal Jumphost`: index.html#install-bare-metal-jumphost
-.. _`Verifying the Setup`: index.html#verifying-the-setup