Renamed install instructions folder according to docs directive

Change-Id: I8970be0bcbed501e43d6fb76af1278881274f69a
Signed-off-by: Sofia Wallin <sofia.wallin@ericsson.com>

1 files changed, 79 insertions, 0 deletions

diff --git a/docs/installationprocedure/requirements.rst b/docs/installationprocedure/requirements.rst
new file mode 100644
index 00000000..d54d584b
--- /dev/null
+++ b/docs/installationprocedure/requirements.rst
@@ -0,0 +1,79 @@
+Setup Requirements
+==================
+
+Jumphost Requirements
+---------------------
+
+The Jumphost requirements are outlined below:
+
+1.     CentOS 7 (from ISO or self-installed).
+
+2.     Root access.
+
+3.     libvirt virtualization support.
+
+4.     minimum 1 networks and maximum 5 networks, multiple NIC and/or VLAN
+       combinations are supported.  This is virtualized for a VM deployment.
+
+5.     The Colorado Apex RPMs and their dependencies.
+
+6.     16 GB of RAM for a bare metal deployment, 64 GB of RAM for a VM
+       deployment.
+
+Network Requirements
+--------------------
+
+Network requirements include:
+
+1.     No DHCP or TFTP server running on networks used by OPNFV.
+
+2.     1-5 separate networks with connectivity between Jumphost and nodes.
+
+       -  Control Plane (Provisioning)
+
+       -  Private Tenant-Networking Network*
+
+       -  External Network
+
+       -  Storage Network*
+
+       -  Internal API Network* (required for IPv6 \*\*)
+
+3.     Lights out OOB network access from Jumphost with IPMI node enabled
+       (bare metal deployment only).
+
+4.     External network is a routable network from outside the cloud,
+       deployment. The External network is where public internet access would
+       reside if available.
+
+\* *These networks can be combined with each other or all combined on the
+    Control Plane network.*
+\* *Non-External networks will be consolidated to the Control Plane network
+    if not specifically configured.*
+\*\* *Internal API network, by default, is collapsed with provisioning in IPv4
+     deployments, this is not possible with the current lack of PXE boot
+     support and therefore the API network is required to be its own
+     network in an IPv6 deployment.*
+
+Bare Metal Node Requirements
+----------------------------
+
+Bare metal nodes require:
+
+1.     IPMI enabled on OOB interface for power control.
+
+2.     BIOS boot priority should be PXE first then local hard disk.
+
+3.     BIOS PXE interface should include Control Plane network mentioned above.
+
+Execution Requirements (Bare Metal Only)
+----------------------------------------
+
+In order to execute a deployment, one must gather the following information:
+
+1.     IPMI IP addresses for the nodes.
+
+2.     IPMI login information for the nodes (user/pass).
+
+3.     MAC address of Control Plane / Provisioning interfaces of the overcloud
+       nodes.