1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
|
.. This work is licensed under a Creative Commons Attribution 4.0 International
.. License.
.. http://creativecommons.org/licenses/by/4.0
================================
Test Results for os-nosdn-kvm-ha
================================
.. toctree::
:maxdepth: 2
fuel
====
.. _Grafana: http://testresults.opnfv.org/grafana/dashboard/db/yardstick-main
.. _POD2: https://wiki.opnfv.org/pharos?&#community_test_labs
Overview of test results
------------------------
See Grafana_ for viewing test result metrics for each respective test case. It
is possible to chose which specific scenarios to look at, and then to zoom in
on the details of each run test scenario as well.
All of the test case results below are based on 4 scenario test
runs, each run on the Ericsson POD2_ or LF POD2_ between August 24 and 30 in
2016.
TC002
-----
The round-trip-time (RTT) between 2 VMs on different blades is measured using
ping. Most test run measurements result on average between 0.44 and 0.75 ms.
A few runs start with a 0.65 - 0.68 ms RTT spike (This could be because of
normal ARP handling). One test run has a greater RTT spike of 1.49 ms.
To be able to draw conclusions more runs should be made. SLA set to 10 ms.
The SLA value is used as a reference, it has not been defined by OPNFV.
TC005
-----
The IO read bandwidth looks similar between different dates, with an
average between approx. 92 and 204 MB/s. Within each test run the results
vary, with a minimum 2 MB/s and maximum 819 MB/s on the totality. Most runs
have a minimum BW of 3 MB/s (one run at 2 MB/s). The maximum BW varies more in
absolute numbers between the dates, between 238 and 819 MB/s.
SLA set to 400 MB/s. The SLA value is used as a reference, it has not been
defined by OPNFV.
TC010
-----
The measurements for memory latency are similar between test dates and result
in approx. 2.07 ns. The variations within each test run are similar, between
1.41 and 3.53 ns.
SLA set to 30 ns. The SLA value is used as a reference, it has not been defined
by OPNFV.
TC011
-----
Packet delay variation between 2 VMs on different blades is measured using
Iperf3. The reported packet delay variation varies between 0.0051 and 0.0243 ms,
with an average delay variation between 0.0081 ms and 0.0195 ms.
TC012
-----
Between test dates, the average measurements for memory bandwidth result in
approx. 13.6 GB/s. Within each test run the results vary more, with a minimal
BW of 6.09 GB/s and maximum of 16.47 GB/s on the totality.
SLA set to 15 GB/s. The SLA value is used as a reference, it has not been
defined by OPNFV.
TC014
-----
The Unixbench processor test run results vary between scores 2316 and 3619,
one result each date.
No SLA set.
TC037
-----
The amount of packets per second (PPS) and round trip times (RTT) between 2 VMs
on different blades are measured when increasing the amount of UDP flows sent
between the VMs using pktgen as packet generator tool.
Round trip times and packet throughput between VMs can typically be affected by
the amount of flows set up and result in higher RTT and less PPS throughput.
The RTT results are similar throughout the different test dates and runs at
approx. 15 ms. Some test runs show an increase with many flows, in the range
towards 16 to 17 ms. One exception standing out is Feb. 15 where the average
RTT is stable at approx. 13 ms. The PPS results are not as consistent as the
RTT results.
In some test runs when running with less than approx. 10000 flows the PPS
throughput is normally flatter compared to when running with more flows, after
which the PPS throughput decreases. Around 20 percent decrease in the worst
case. For the other test runs there is however no significant change to the PPS
throughput when the number of flows are increased. In some test runs the PPS
is also greater with 1000000 flows compared to other test runs where the PPS
result is less with only 2 flows.
The average PPS throughput in the different runs varies between 414000 and
452000 PPS. The total amount of packets in each test run is approx. 7500000 to
8200000 packets. One test run Feb. 15 sticks out with a PPS average of
558000 and approx. 1100000 packets in total (same as the on mentioned earlier
for RTT results).
There are lost packets reported in most of the test runs. There is no observed
correlation between the amount of flows and the amount of lost packets.
The lost amount of packets normally range between 100 and 1000 per test run,
but there are spikes in the range of 10000 lost packets as well, and even
more in a rare cases.
CPU utilization statistics are collected during UDP flows sent between the VMs
using pktgen as packet generator tool. The average measurements for CPU
utilization ratio vary between 1% to 2%. The peak of CPU utilization ratio
appears around 7%.
TC069
-----
Between test dates, the average measurements for memory bandwidth vary between
22.6 and 29.1 GB/s. Within each test run the results vary more, with a minimal
BW of 20.0 GB/s and maximum of 29.5 GB/s on the totality.
SLA set to 6 GB/s. The SLA value is used as a reference, it has not been
defined by OPNFV.
TC070
-----
The amount of packets per second (PPS) and round trip times (RTT) between 2 VMs
on different blades are measured when increasing the amount of UDP flows sent
between the VMs using pktgen as packet generator tool.
Round trip times and packet throughput between VMs can typically be affected by
the amount of flows set up and result in higher RTT and less PPS throughput.
The RTT results are similar throughout the different test dates and runs at
approx. 15 ms. Some test runs show an increase with many flows, in the range
towards 16 to 17 ms. One exception standing out is Feb. 15 where the average
RTT is stable at approx. 13 ms. The PPS results are not as consistent as the
RTT results.
In some test runs when running with less than approx. 10000 flows the PPS
throughput is normally flatter compared to when running with more flows, after
which the PPS throughput decreases. Around 20 percent decrease in the worst
case. For the other test runs there is however no significant change to the PPS
throughput when the number of flows are increased. In some test runs the PPS
is also greater with 1000000 flows compared to other test runs where the PPS
result is less with only 2 flows.
The average PPS throughput in the different runs varies between 414000 and
452000 PPS. The total amount of packets in each test run is approx. 7500000 to
8200000 packets. One test run Feb. 15 sticks out with a PPS average of
558000 and approx. 1100000 packets in total (same as the on mentioned earlier
for RTT results).
There are lost packets reported in most of the test runs. There is no observed
correlation between the amount of flows and the amount of lost packets.
The lost amount of packets normally range between 100 and 1000 per test run,
but there are spikes in the range of 10000 lost packets as well, and even
more in a rare cases.
Memory utilization statistics are collected during UDP flows sent between the
VMs using pktgen as packet generator tool. The average measurements for memory
utilization vary between 225MB to 246MB. The peak of memory utilization appears
around 340MB.
TC071
-----
The amount of packets per second (PPS) and round trip times (RTT) between 2 VMs
on different blades are measured when increasing the amount of UDP flows sent
between the VMs using pktgen as packet generator tool.
Round trip times and packet throughput between VMs can typically be affected by
the amount of flows set up and result in higher RTT and less PPS throughput.
The RTT results are similar throughout the different test dates and runs at
approx. 15 ms. Some test runs show an increase with many flows, in the range
towards 16 to 17 ms. One exception standing out is Feb. 15 where the average
RTT is stable at approx. 13 ms. The PPS results are not as consistent as the
RTT results.
In some test runs when running with less than approx. 10000 flows the PPS
throughput is normally flatter compared to when running with more flows, after
which the PPS throughput decreases. Around 20 percent decrease in the worst
case. For the other test runs there is however no significant change to the PPS
throughput when the number of flows are increased. In some test runs the PPS
is also greater with 1000000 flows compared to other test runs where the PPS
result is less with only 2 flows.
The average PPS throughput in the different runs varies between 414000 and
452000 PPS. The total amount of packets in each test run is approx. 7500000 to
8200000 packets. One test run Feb. 15 sticks out with a PPS average of
558000 and approx. 1100000 packets in total (same as the on mentioned earlier
for RTT results).
There are lost packets reported in most of the test runs. There is no observed
correlation between the amount of flows and the amount of lost packets.
The lost amount of packets normally range between 100 and 1000 per test run,
but there are spikes in the range of 10000 lost packets as well, and even
more in a rare cases.
Cache utilization statistics are collected during UDP flows sent between the
VMs using pktgen as packet generator tool. The average measurements for cache
utilization vary between 205MB to 212MB.
TC072
-----
The amount of packets per second (PPS) and round trip times (RTT) between 2 VMs
on different blades are measured when increasing the amount of UDP flows sent
between the VMs using pktgen as packet generator tool.
Round trip times and packet throughput between VMs can typically be affected by
the amount of flows set up and result in higher RTT and less PPS throughput.
The RTT results are similar throughout the different test dates and runs at
approx. 15 ms. Some test runs show an increase with many flows, in the range
towards 16 to 17 ms. One exception standing out is Feb. 15 where the average
RTT is stable at approx. 13 ms. The PPS results are not as consistent as the
RTT results.
In some test runs when running with less than approx. 10000 flows the PPS
throughput is normally flatter compared to when running with more flows, after
which the PPS throughput decreases. Around 20 percent decrease in the worst
case. For the other test runs there is however no significant change to the PPS
throughput when the number of flows are increased. In some test runs the PPS
is also greater with 1000000 flows compared to other test runs where the PPS
result is less with only 2 flows.
The average PPS throughput in the different runs varies between 414000 and
452000 PPS. The total amount of packets in each test run is approx. 7500000 to
8200000 packets. One test run Feb. 15 sticks out with a PPS average of
558000 and approx. 1100000 packets in total (same as the on mentioned earlier
for RTT results).
There are lost packets reported in most of the test runs. There is no observed
correlation between the amount of flows and the amount of lost packets.
The lost amount of packets normally range between 100 and 1000 per test run,
but there are spikes in the range of 10000 lost packets as well, and even
more in a rare cases.
Network utilization statistics are collected during UDP flows sent between the
VMs using pktgen as packet generator tool. Total number of packets received per
second was average on 200 kpps and total number of packets transmitted per
second was average on 600 kpps.
Detailed test results
---------------------
The scenario was run on Ericsson POD2_ and LF POD2_ with:
Fuel 9.0
OpenStack Mitaka
OpenVirtualSwitch 2.5.90
OpenDayLight Beryllium
Rationale for decisions
-----------------------
Pass
Tests were successfully executed and metrics collected.
No SLA was verified. To be decided on in next release of OPNFV.
Conclusions and recommendations
-------------------------------
The pktgen test configuration has a relatively large base effect on RTT in
TC037 compared to TC002, where there is no background load at all. Approx.
15 ms compared to approx. 0.5 ms, which is more than a 3000 percentage
difference in RTT results.
Especially RTT and throughput come out with better results than for instance
the *fuel-os-nosdn-nofeature-ha* scenario does. The reason for this should
probably be further analyzed and understood. Also of interest could be
to make further analyzes to find patterns and reasons for lost traffic.
Also of interest could be to see if there are continuous variations where
some test cases stand out with better or worse results than the general test
case.
|
