From 197cef580315e942dffb517412374fd297c34b33 Mon Sep 17 00:00:00 2001 From: JingLu5 Date: Sun, 18 Sep 2016 15:31:20 +0800 Subject: Update scenario test results files for Colorado release JIRA: YARDSTICK-351 Also fix some errors in userguide Change-Id: Icd70f1cc99d735c62e235808eb721a7482e0a218 Signed-off-by: JingLu5 --- docs/results/fuel-os-odl_l2-nofeature-ha.rst | 271 --------------------------- 1 file changed, 271 deletions(-) delete mode 100644 docs/results/fuel-os-odl_l2-nofeature-ha.rst (limited to 'docs/results/fuel-os-odl_l2-nofeature-ha.rst') diff --git a/docs/results/fuel-os-odl_l2-nofeature-ha.rst b/docs/results/fuel-os-odl_l2-nofeature-ha.rst deleted file mode 100644 index e9ef8fe65..000000000 --- a/docs/results/fuel-os-odl_l2-nofeature-ha.rst +++ /dev/null @@ -1,271 +0,0 @@ -.. This work is licensed under a Creative Commons Attribution 4.0 International -.. License. -.. http://creativecommons.org/licenses/by/4.0 - - -============================================ -Test Results for fuel-os-odl_l2-nofeature-ha -============================================ - -.. toctree:: - :maxdepth: 2 - - -Details -======= - -.. _Grafana: http://testresults.opnfv.org/grafana/dashboard/db/yardstick-main -.. _POD2: https://wiki.opnfv.org/pharos?&#community_test_labs - -Overview of test results ------------------------- - -See Grafana_ for viewing test result metrics for each respective test case. It -is possible to chose which specific scenarios to look at, and then to zoom in -on the details of each run test scenario as well. - -All of the test case results below are based on 4 scenario test -runs, each run on the Ericsson POD2_ or LF POD2_ between August 25 and 29 in -2016. - -TC002 ------ -The round-trip-time (RTT) between 2 VMs on different blades is measured using -ping. Most test run measurements result on average between 0.5 and 0.6 ms. -A few runs start with a 1 - 1.5 ms RTT spike (This could be because of normal ARP -handling). One test run has a greater RTT spike of 1.9 ms, which is the same -one with the 0.7 ms average. The other runs have no similar spike at all. -To be able to draw conclusions more runs should be made. -SLA set to 10 ms. The SLA value is used as a reference, it has not -been defined by OPNFV. - -TC005 ------ -The IO read bandwidth looks similar between different dates, with an -average between approx. 170 and 200 MB/s. Within each test run the results -vary, with a minimum 2 MB/s and maximum 838 MB/s on the totality. Most runs -have a minimum BW of 3 MB/s (two runs at 2 MB/s). The maximum BW varies more in -absolute numbers between the dates, between 617 and 838 MB/s. -SLA set to 400 MB/s. The SLA value is used as a reference, it has not been -defined by OPNFV. - -TC010 ------ -The measurements for memory latency are similar between test dates and result -in approx. 1.2 ns. The variations within each test run are similar, between -1.215 and 1.219 ns. One exception is February 16, where the average is 1.222 -and varies between 1.22 and 1.28 ns. -SLA set to 30 ns. The SLA value is used as a reference, it has not been defined -by OPNFV. - -TC011 ------ -Packet delay variation between 2 VMs on different blades is measured using -Iperf3. On the first date the reported packet delay variation varies between -0.0025 and 0.011 ms, with an average delay variation of 0.0067 ms. -On the second date the delay variation varies between 0.002 and 0.006 ms, with -an average delay variation of 0.004 ms. - -TC012 ------ -Between test dates, the average measurements for memory bandwidth vary between -17.4 and 17.9 GB/s. Within each test run the results vary more, with a minimal -BW of 16.4 GB/s and maximum of 18.2 GB/s on the totality. -SLA set to 15 GB/s. The SLA value is used as a reference, it has not been -defined by OPNFV. - -TC014 ------ -The Unixbench processor test run results vary between scores 3080 and 3240, -one result each date. The average score on the total is 3150. -No SLA set. - -TC037 ------ -The amount of packets per second (PPS) and round trip times (RTT) between 2 VMs -on different blades are measured when increasing the amount of UDP flows sent -between the VMs using pktgen as packet generator tool. - -Round trip times and packet throughput between VMs can typically be affected by -the amount of flows set up and result in higher RTT and less PPS throughput. - -The RTT results are similar throughout the different test dates and runs at -approx. 15 ms. Some test runs show an increase with many flows, in the range -towards 16 to 17 ms. One exception standing out is Feb. 15 where the average -RTT is stable at approx. 13 ms. The PPS results are not as consistent as the -RTT results. -In some test runs when running with less than approx. 10000 flows the PPS -throughput is normally flatter compared to when running with more flows, after -which the PPS throughput decreases. Around 20 percent decrease in the worst -case. For the other test runs there is however no significant change to the PPS -throughput when the number of flows are increased. In some test runs the PPS -is also greater with 1000000 flows compared to other test runs where the PPS -result is less with only 2 flows. - -The average PPS throughput in the different runs varies between 414000 and -452000 PPS. The total amount of packets in each test run is approx. 7500000 to -8200000 packets. One test run Feb. 15 sticks out with a PPS average of -558000 and approx. 1100000 packets in total (same as the on mentioned earlier -for RTT results). - -There are lost packets reported in most of the test runs. There is no observed -correlation between the amount of flows and the amount of lost packets. -The lost amount of packets normally range between 100 and 1000 per test run, -but there are spikes in the range of 10000 lost packets as well, and even -more in a rare cases. - -CPU utilization statistics are collected during UDP flows sent between the VMs -using pktgen as packet generator tool. The average measurements for CPU -utilization ratio vary between 1% to 2%. The peak of CPU utilization ratio -appears around 7%. - -TC069 -Between test dates, the average measurements for memory bandwidth vary between -15.5 and 25.4 GB/s. Within each test run the results vary more, with a minimal -BW of 9.7 GB/s and maximum of 29.5 GB/s on the totality. -SLA set to 6 GB/s. The SLA value is used as a reference, it has not been -defined by OPNFV. - - -TC070 -The amount of packets per second (PPS) and round trip times (RTT) between 2 VMs -on different blades are measured when increasing the amount of UDP flows sent -between the VMs using pktgen as packet generator tool. - -Round trip times and packet throughput between VMs can typically be affected by -the amount of flows set up and result in higher RTT and less PPS throughput. - -The RTT results are similar throughout the different test dates and runs at -approx. 15 ms. Some test runs show an increase with many flows, in the range -towards 16 to 17 ms. One exception standing out is Feb. 15 where the average -RTT is stable at approx. 13 ms. The PPS results are not as consistent as the -RTT results. -In some test runs when running with less than approx. 10000 flows the PPS -throughput is normally flatter compared to when running with more flows, after -which the PPS throughput decreases. Around 20 percent decrease in the worst -case. For the other test runs there is however no significant change to the PPS -throughput when the number of flows are increased. In some test runs the PPS -is also greater with 1000000 flows compared to other test runs where the PPS -result is less with only 2 flows. - -The average PPS throughput in the different runs varies between 414000 and -452000 PPS. The total amount of packets in each test run is approx. 7500000 to -8200000 packets. One test run Feb. 15 sticks out with a PPS average of -558000 and approx. 1100000 packets in total (same as the on mentioned earlier -for RTT results). - -There are lost packets reported in most of the test runs. There is no observed -correlation between the amount of flows and the amount of lost packets. -The lost amount of packets normally range between 100 and 1000 per test run, -but there are spikes in the range of 10000 lost packets as well, and even -more in a rare cases. - -Memory utilization statistics are collected during UDP flows sent between the -VMs using pktgen as packet generator tool. The average measurements for memory -utilization vary between 225MB to 246MB. The peak of memory utilization appears -around 340MB. - -TC071 -The amount of packets per second (PPS) and round trip times (RTT) between 2 VMs -on different blades are measured when increasing the amount of UDP flows sent -between the VMs using pktgen as packet generator tool. - -Round trip times and packet throughput between VMs can typically be affected by -the amount of flows set up and result in higher RTT and less PPS throughput. - -The RTT results are similar throughout the different test dates and runs at -approx. 15 ms. Some test runs show an increase with many flows, in the range -towards 16 to 17 ms. One exception standing out is Feb. 15 where the average -RTT is stable at approx. 13 ms. The PPS results are not as consistent as the -RTT results. -In some test runs when running with less than approx. 10000 flows the PPS -throughput is normally flatter compared to when running with more flows, after -which the PPS throughput decreases. Around 20 percent decrease in the worst -case. For the other test runs there is however no significant change to the PPS -throughput when the number of flows are increased. In some test runs the PPS -is also greater with 1000000 flows compared to other test runs where the PPS -result is less with only 2 flows. - -The average PPS throughput in the different runs varies between 414000 and -452000 PPS. The total amount of packets in each test run is approx. 7500000 to -8200000 packets. One test run Feb. 15 sticks out with a PPS average of -558000 and approx. 1100000 packets in total (same as the on mentioned earlier -for RTT results). - -There are lost packets reported in most of the test runs. There is no observed -correlation between the amount of flows and the amount of lost packets. -The lost amount of packets normally range between 100 and 1000 per test run, -but there are spikes in the range of 10000 lost packets as well, and even -more in a rare cases. - -Cache utilization statistics are collected during UDP flows sent between the -VMs using pktgen as packet generator tool. The average measurements for cache -utilization vary between 205MB to 212MB. - -TC072 -The amount of packets per second (PPS) and round trip times (RTT) between 2 VMs -on different blades are measured when increasing the amount of UDP flows sent -between the VMs using pktgen as packet generator tool. - -Round trip times and packet throughput between VMs can typically be affected by -the amount of flows set up and result in higher RTT and less PPS throughput. - -The RTT results are similar throughout the different test dates and runs at -approx. 15 ms. Some test runs show an increase with many flows, in the range -towards 16 to 17 ms. One exception standing out is Feb. 15 where the average -RTT is stable at approx. 13 ms. The PPS results are not as consistent as the -RTT results. -In some test runs when running with less than approx. 10000 flows the PPS -throughput is normally flatter compared to when running with more flows, after -which the PPS throughput decreases. Around 20 percent decrease in the worst -case. For the other test runs there is however no significant change to the PPS -throughput when the number of flows are increased. In some test runs the PPS -is also greater with 1000000 flows compared to other test runs where the PPS -result is less with only 2 flows. - -The average PPS throughput in the different runs varies between 414000 and -452000 PPS. The total amount of packets in each test run is approx. 7500000 to -8200000 packets. One test run Feb. 15 sticks out with a PPS average of -558000 and approx. 1100000 packets in total (same as the on mentioned earlier -for RTT results). - -There are lost packets reported in most of the test runs. There is no observed -correlation between the amount of flows and the amount of lost packets. -The lost amount of packets normally range between 100 and 1000 per test run, -but there are spikes in the range of 10000 lost packets as well, and even -more in a rare cases. - -Network utilization statistics are collected during UDP flows sent between the -VMs using pktgen as packet generator tool. Total number of packets received per -second was average on 200 kpps and total number of packets transmitted per -second was average on 600 kpps. - -Detailed test results ---------------------- -The scenario was run on Ericsson POD2_ and LF POD2_ with: -Fuel 9.0 -OpenStack Mitaka -OpenVirtualSwitch 2.5.90 -OpenDayLight Beryllium - -Rationale for decisions ------------------------ -Pass - -Tests were successfully executed and metrics collected. -No SLA was verified. To be decided on in next release of OPNFV. - -Conclusions and recommendations -------------------------------- -The pktgen test configuration has a relatively large base effect on RTT in -TC037 compared to TC002, where there is no background load at all. Approx. -15 ms compared to approx. 0.5 ms, which is more than a 3000 percentage -difference in RTT results. -Especially RTT and throughput come out with better results than for instance -the *fuel-os-nosdn-nofeature-ha* scenario does. The reason for this should -probably be further analyzed and understood. Also of interest could be -to make further analyzes to find patterns and reasons for lost traffic. -Also of interest could be to see if there are continuous variations where -some test cases stand out with better or worse results than the general test -case. - -- cgit 1.2.3-korg