diff options
Diffstat (limited to 'docs/results/fuel-os-onos-nofeature-ha.rst')
| -rw-r--r-- | docs/results/fuel-os-onos-nofeature-ha.rst | 124 |
1 files changed, 116 insertions, 8 deletions
diff --git a/docs/results/fuel-os-onos-nofeature-ha.rst b/docs/results/fuel-os-onos-nofeature-ha.rst index 5e94e9b6f..4e7345820 100644 --- a/docs/results/fuel-os-onos-nofeature-ha.rst +++ b/docs/results/fuel-os-onos-nofeature-ha.rst @@ -14,25 +14,133 @@ Test Results for fuel-os-onos-nofeature-ha Details ======= -.. after this doc is filled, remove all comments and include the scenario in -.. results.rst by removing the comment on the file name. - +.. _Grafana: http://130.211.154.108/grafana/dashboard/db/yardstick-main +.. _POD2: https://wiki.opnfv.org/pharos?&#community_test_labs Overview of test results ------------------------ -.. general on metrics collected, number of iterations +See Grafana_ for viewing test result metrics for each respective test case. It +is possible to chose which specific scenarios to look at, and then to zoom in +on the details of each run test scenario as well. + +All of the test case results below are based on 7 scenario test +runs, each run on the Ericsson POD2_ between February 13 and 21 in 2016. Test +case TC011_ is not reported on due to an InfluxDB issue. +The best would be to have more runs to draw better conclusions from, but these +are the only runs available at the time of OPNFV R2 release. + +TC002 +----- +The round-trip-time (RTT) between 2 VMs on different blades is measured using +ping. The majority (5) of the test run measurements result in an average +between 0.4 and 0.5 ms. The other 2 dates stick out with an RTT average of 0.9 +to 1 ms. +The majority of the runs start with a 1 - 1.5 ms RTT spike (This could be +because of normal ARP handling). One test run has a greater RTT spike of 4 ms, +which is the same one with the 1 ms RTT average. The other runs have no similar +spike at all. To be able to draw conclusions more runs should be made. +SLA set to 10 ms. The SLA value is used as a reference, it has not +been defined by OPNFV. + +TC005 +----- +The IO read bandwidth looks similar between different dates, with an +average between approx. 170 and 185 MB/s. Within each test run the results +vary, with a minimum of 2 MB/s and maximum of 690MB/s on the totality. Most +runs have a minimum BW of 3 MB/s (one run at 2 MB/s). The maximum BW varies +more in absolute numbers between the dates, between 560 and 690 MB/s. +SLA set to 400 MB/s. The SLA value is used as a reference, it has not been +defined by OPNFV. + +TC010 +----- +The measurements for memory latency are similar between test dates and result +in a little less average than 1.22 ns. The variations within each test run are +similar, between 1.213 and 1.226 ns. One exception is the first date, where the +average is 1.223 and varies between 1.215 and 1.275 ns. +SLA set to 30 ns. The SLA value is used as a reference, it has not been defined +by OPNFV. + +TC011 +----- +For this scenario no results are available to report on. Reason is an +integer/floating point issue regarding how InfluxDB is populated with +result data from the test runs. The issue was fixed but not in time to produce +input for this report. + +TC012 +----- +Between test dates the average measurements for memory bandwidth vary between +17.1 and 18.1 GB/s. Within each test run the results vary more, with a minimal +BW of 15.5 GB/s and maximum of 18.2 GB/s on the totality. +SLA set to 15 GB/s. The SLA value is used as a reference, it has not been +defined by OPNFV. + +TC014 +----- +The Unixbench processor test run results vary between scores 3100 and 3260, +one result each date. The average score on the total is 3170. +No SLA set. + +TC037 +----- +The amount of packets per second (PPS) and round trip times (RTT) between 2 VMs +on different blades are measured when increasing the amount of UDP flows sent +between the VMs using pktgen as packet generator tool. + +Round trip times and packet throughput between VMs can typically be affected by +the amount of flows set up and result in higher RTT and less PPS throughput. + +There seems to be mainly two result types. One type a high and flatter +PPS throughput not very much affected by the number of flows. Here also the +average RTT is stable around 13 ms throughout all the test runs. + +The second type starts with a slightly lower PPS in the beginning than type +one, and decreases even further when passing approx. 10000 flows. Here also the +average RTT tends to start at approx. 15 ms ending with an average of 17 to 18 +ms with the maximum amount of flows running. + +Result type one can with the maximum amount of flows have a greater PPS than +the second type with the minimum amount of flows. + +For result type one the average PPS throughput in the different runs varies +between 399000 and 447000 PPS. The total amount of packets in each test run +is between approx. 7000000 and 10200000 packets. +The second result type has a PPS average of between 602000 and 621000 PPS and a +total packet amount between 10900000 and 13500000 packets. + +There are lost packets reported in many of the test runs. There is no observed +correlation between the amount of flows and the amount of lost packets. +The lost amount of packets normally range between 100 and 1000 per test run, +but there are spikes in the range of 10000 lost packets as well, and even +more in a rare cases. Some case is in the range of one million lost packets. Detailed test results --------------------- - -.. info on lab, installer, scenario +The scenario was run on Ericsson POD2_ with: +Fuel 8.0 +OpenStack Liberty +OpenVirtualSwitch 2.3.1 +OpenNetworkOperatingSystem Drake Rationale for decisions ----------------------- -.. result analysis, pass/fail +Pass + +Tests were successfully executed and metrics collected. +No SLA was verified. To be decided on in next release of OPNFV. Conclusions and recommendations ------------------------------- +The pktgen test configuration has a relatively large base effect on RTT in +TC037 compared to TC002, where there is no background load at all. Approx. +15 ms compared to approx. 0.5 ms, which is more than a 3000 percentage +difference in RTT results. +Especially RTT and throughput come out with better results than for instance +the *fuel-os-nosdn-nofeature-ha* scenario does. The reason for this should +probably be further analyzed and understood. Also of interest could be +to make further analyzes to find patterns and reasons for lost traffic. +Also of interest could be to see why there are variations in some test cases, +especially visible in TC037. -.. did the expected behavior occured? |