From e44e3482bdb4d0ebde2d8b41830ac2cdb07948fb Mon Sep 17 00:00:00 2001 From: Yang Zhang Date: Fri, 28 Aug 2015 09:58:54 +0800 Subject: Add qemu 2.4.0 Change-Id: Ic99cbad4b61f8b127b7dc74d04576c0bcbaaf4f5 Signed-off-by: Yang Zhang --- qemu/roms/u-boot/doc/README.switch_config | 25 +++++++++++++++++++++++++ 1 file changed, 25 insertions(+) create mode 100644 qemu/roms/u-boot/doc/README.switch_config (limited to 'qemu/roms/u-boot/doc/README.switch_config') diff --git a/qemu/roms/u-boot/doc/README.switch_config b/qemu/roms/u-boot/doc/README.switch_config new file mode 100644 index 000000000..f8903738e --- /dev/null +++ b/qemu/roms/u-boot/doc/README.switch_config @@ -0,0 +1,25 @@ +On the enbw_cmc board is a KSZ8864RMN switch which needs +configured through spi before working. This is done on +startup from u-boot through a config file stored at an +address specified in the "hwconfig" environment variable, +subcommand "config". + +For example on the enbw_cmc board: + +hwconfig=switch:lan=on,pwl=off,config=0x60160000 + +The file has the following structure: + +- a comment starts with a '#' or a ';' and ends with a newline +- The switch needs for its config a reg/value pair, so we + have two columns in the file: + reg : contains the register address + value: contains a 8 bit register value + This 2 columns are seperated through space or tab. + +example (minimal configuration on the enbw_cmc board): + +;reg value comment +;----------------------------------------- +0x01 0x00 +0x01 0x01 ; Start Switch with this configuration -- cgit 1.2.3-korg