From e44e3482bdb4d0ebde2d8b41830ac2cdb07948fb Mon Sep 17 00:00:00 2001 From: Yang Zhang Date: Fri, 28 Aug 2015 09:58:54 +0800 Subject: Add qemu 2.4.0 Change-Id: Ic99cbad4b61f8b127b7dc74d04576c0bcbaaf4f5 Signed-off-by: Yang Zhang --- qemu/docs/specs/vmw_pvscsi-spec.txt | 92 +++++++++++++++++++++++++++++++++++++ 1 file changed, 92 insertions(+) create mode 100644 qemu/docs/specs/vmw_pvscsi-spec.txt (limited to 'qemu/docs/specs/vmw_pvscsi-spec.txt') diff --git a/qemu/docs/specs/vmw_pvscsi-spec.txt b/qemu/docs/specs/vmw_pvscsi-spec.txt new file mode 100644 index 000000000..49affb2a4 --- /dev/null +++ b/qemu/docs/specs/vmw_pvscsi-spec.txt @@ -0,0 +1,92 @@ +General Description +=================== + +This document describes VMWare PVSCSI device interface specification. +Created by Dmitry Fleytman (dmitry@daynix.com), Daynix Computing LTD. +Based on source code of PVSCSI Linux driver from kernel 3.0.4 + +PVSCSI Device Interface Overview +================================ + +The interface is based on memory area shared between hypervisor and VM. +Memory area is obtained by driver as device IO memory resource of +PVSCSI_MEM_SPACE_SIZE length. +The shared memory consists of registers area and rings area. +The registers area is used to raise hypervisor interrupts and issue device +commands. The rings area is used to transfer data descriptors and SCSI +commands from VM to hypervisor and to transfer messages produced by +hypervisor to VM. Data itself is transferred via virtual scatter-gather DMA. + +PVSCSI Device Registers +======================= + +The length of the registers area is 1 page (PVSCSI_MEM_SPACE_COMMAND_NUM_PAGES). +The structure of the registers area is described by the PVSCSIRegOffset enum. +There are registers to issue device command (with optional short data), +issue device interrupt, control interrupts masking. + +PVSCSI Device Rings +=================== + +There are three rings in shared memory: + + 1. Request ring (struct PVSCSIRingReqDesc *req_ring) + - ring for OS to device requests + 2. Completion ring (struct PVSCSIRingCmpDesc *cmp_ring) + - ring for device request completions + 3. Message ring (struct PVSCSIRingMsgDesc *msg_ring) + - ring for messages from device. + This ring is optional and the guest might not configure it. +There is a control area (struct PVSCSIRingsState *rings_state) used to control +rings operation. + +PVSCSI Device to Host Interrupts +================================ +There are following interrupt types supported by PVSCSI device: + 1. Completion interrupts (completion ring notifications): + PVSCSI_INTR_CMPL_0 + PVSCSI_INTR_CMPL_1 + 2. Message interrupts (message ring notifications): + PVSCSI_INTR_MSG_0 + PVSCSI_INTR_MSG_1 + +Interrupts are controlled via PVSCSI_REG_OFFSET_INTR_MASK register +Bit set means interrupt enabled, bit cleared - disabled + +Interrupt modes supported are legacy, MSI and MSI-X +In case of legacy interrupts, register PVSCSI_REG_OFFSET_INTR_STATUS +is used to check which interrupt has arrived. Interrupts are +acknowledged when the corresponding bit is written to the interrupt +status register. + +PVSCSI Device Operation Sequences +================================= + +1. Startup sequence: + a. Issue PVSCSI_CMD_ADAPTER_RESET command; + aa. Windows driver reads interrupt status register here; + b. Issue PVSCSI_CMD_SETUP_MSG_RING command with no additional data, + check status and disable device messages if error returned; + (Omitted if device messages disabled by driver configuration) + c. Issue PVSCSI_CMD_SETUP_RINGS command, provide rings configuration + as struct PVSCSICmdDescSetupRings; + d. Issue PVSCSI_CMD_SETUP_MSG_RING command again, provide + rings configuration as struct PVSCSICmdDescSetupMsgRing; + e. Unmask completion and message (if device messages enabled) interrupts. + +2. Shutdown sequences + a. Mask interrupts; + b. Flush request ring using PVSCSI_REG_OFFSET_KICK_NON_RW_IO; + c. Issue PVSCSI_CMD_ADAPTER_RESET command. + +3. Send request + a. Fill next free request ring descriptor; + b. Issue PVSCSI_REG_OFFSET_KICK_RW_IO for R/W operations; + or PVSCSI_REG_OFFSET_KICK_NON_RW_IO for other operations. + +4. Abort command + a. Issue PVSCSI_CMD_ABORT_CMD command; + +5. Request completion processing + a. Upon completion interrupt arrival process completion + and message (if enabled) rings. -- cgit 1.2.3-korg