From e09b41010ba33a20a87472ee821fa407a5b8da36 Mon Sep 17 00:00:00 2001 From: José Pekkarinen Date: Mon, 11 Apr 2016 10:41:07 +0300 Subject: These changes are the raw update to linux-4.4.6-rt14. Kernel sources are taken from kernel.org, and rt patch from the rt wiki download page. MIME-Version: 1.0 Content-Type: text/plain; charset=UTF-8 Content-Transfer-Encoding: 8bit During the rebasing, the following patch collided: Force tick interrupt and get rid of softirq magic(I70131fb85). Collisions have been removed because its logic was found on the source already. Change-Id: I7f57a4081d9deaa0d9ccfc41a6c8daccdee3b769 Signed-off-by: José Pekkarinen --- kernel/Documentation/usb/usb-serial.txt | 12 +++++++----- 1 file changed, 7 insertions(+), 5 deletions(-) (limited to 'kernel/Documentation/usb/usb-serial.txt') diff --git a/kernel/Documentation/usb/usb-serial.txt b/kernel/Documentation/usb/usb-serial.txt index 947fa62bc..349f3104f 100644 --- a/kernel/Documentation/usb/usb-serial.txt +++ b/kernel/Documentation/usb/usb-serial.txt @@ -465,12 +465,14 @@ Generic Serial driver device, and does not support any kind of device flow control. All that is required of your device is that it has at least one bulk in endpoint, or one bulk out endpoint. - - To enable the generic driver to recognize your device, build the driver - as a module and load it by the following invocation: + + To enable the generic driver to recognize your device, provide + echo >/sys/bus/usb-serial/drivers/generic/new_id + where the and is replaced with the hex representation of your + device's vendor id and product id. + If the driver is compiled as a module you can also provide one id when + loading the module insmod usbserial vendor=0x#### product=0x#### - where the #### is replaced with the hex representation of your device's - vendor id and product id. This driver has been successfully used to connect to the NetChip USB development board, providing a way to develop USB firmware without -- cgit 1.2.3-korg