From e09b41010ba33a20a87472ee821fa407a5b8da36 Mon Sep 17 00:00:00 2001 From: José Pekkarinen Date: Mon, 11 Apr 2016 10:41:07 +0300 Subject: These changes are the raw update to linux-4.4.6-rt14. Kernel sources are taken from kernel.org, and rt patch from the rt wiki download page. MIME-Version: 1.0 Content-Type: text/plain; charset=UTF-8 Content-Transfer-Encoding: 8bit During the rebasing, the following patch collided: Force tick interrupt and get rid of softirq magic(I70131fb85). Collisions have been removed because its logic was found on the source already. Change-Id: I7f57a4081d9deaa0d9ccfc41a6c8daccdee3b769 Signed-off-by: José Pekkarinen --- kernel/Documentation/i2c/ten-bit-addresses | 4 ++++ 1 file changed, 4 insertions(+) (limited to 'kernel/Documentation/i2c/ten-bit-addresses') diff --git a/kernel/Documentation/i2c/ten-bit-addresses b/kernel/Documentation/i2c/ten-bit-addresses index cdfe13901..7b2d11e53 100644 --- a/kernel/Documentation/i2c/ten-bit-addresses +++ b/kernel/Documentation/i2c/ten-bit-addresses @@ -2,6 +2,10 @@ The I2C protocol knows about two kinds of device addresses: normal 7 bit addresses, and an extended set of 10 bit addresses. The sets of addresses do not intersect: the 7 bit address 0x10 is not the same as the 10 bit address 0x10 (though a single device could respond to both of them). +To avoid ambiguity, the user sees 10 bit addresses mapped to a different +address space, namely 0xa000-0xa3ff. The leading 0xa (= 10) represents the +10 bit mode. This is used for creating device names in sysfs. It is also +needed when instantiating 10 bit devices via the new_device file in sysfs. I2C messages to and from 10-bit address devices have a different format. See the I2C specification for the details. -- cgit 1.2.3-korg