From e09b41010ba33a20a87472ee821fa407a5b8da36 Mon Sep 17 00:00:00 2001 From: José Pekkarinen Date: Mon, 11 Apr 2016 10:41:07 +0300 Subject: These changes are the raw update to linux-4.4.6-rt14. Kernel sources are taken from kernel.org, and rt patch from the rt wiki download page. MIME-Version: 1.0 Content-Type: text/plain; charset=UTF-8 Content-Transfer-Encoding: 8bit During the rebasing, the following patch collided: Force tick interrupt and get rid of softirq magic(I70131fb85). Collisions have been removed because its logic was found on the source already. Change-Id: I7f57a4081d9deaa0d9ccfc41a6c8daccdee3b769 Signed-off-by: José Pekkarinen --- .../bindings/media/stih407-c8sectpfe.txt | 89 ++++++++++++++++++++++ 1 file changed, 89 insertions(+) create mode 100644 kernel/Documentation/devicetree/bindings/media/stih407-c8sectpfe.txt (limited to 'kernel/Documentation/devicetree/bindings/media/stih407-c8sectpfe.txt') diff --git a/kernel/Documentation/devicetree/bindings/media/stih407-c8sectpfe.txt b/kernel/Documentation/devicetree/bindings/media/stih407-c8sectpfe.txt new file mode 100644 index 000000000..d4def767b --- /dev/null +++ b/kernel/Documentation/devicetree/bindings/media/stih407-c8sectpfe.txt @@ -0,0 +1,89 @@ +STMicroelectronics STi c8sectpfe binding +============================================ + +This document describes the c8sectpfe device bindings that is used to get transport +stream data into the SoC on the TS pins, and into DDR for further processing. + +It is typically used in conjunction with one or more demodulator and tuner devices +which converts from the RF to digital domain. Demodulators and tuners are usually +located on an external DVB frontend card connected to SoC TS input pins. + +Currently 7 TS input (tsin) channels are supported on the stih407 family SoC. + +Required properties (controller (parent) node): +- compatible : Should be "stih407-c8sectpfe" + +- reg : Address and length of register sets for each device in + "reg-names" + +- reg-names : The names of the register addresses corresponding to the + registers filled in "reg": + - c8sectpfe: c8sectpfe registers + - c8sectpfe-ram: c8sectpfe internal sram + +- clocks : phandle list of c8sectpfe clocks +- clock-names : should be "c8sectpfe" +See: Documentation/devicetree/bindings/clock/clock-bindings.txt + +- pinctrl-names : a pinctrl state named tsin%d-serial or tsin%d-parallel (where %d is tsin-num) + must be defined for each tsin child node. +- pinctrl-0 : phandle referencing pin configuration for this tsin configuration +See: Documentation/devicetree/bindings/pinctrl/pinctrl-binding.txt + + +Required properties (tsin (child) node): + +- tsin-num : tsin id of the InputBlock (must be between 0 to 6) +- i2c-bus : phandle to the I2C bus DT node which the demodulators & tuners on this tsin channel are connected. +- rst-gpio : reset gpio for this tsin channel. + +Optional properties (tsin (child) node): + +- invert-ts-clk : Bool property to control sense of ts input clock (data stored on falling edge of clk). +- serial-not-parallel : Bool property to configure input bus width (serial on ts_data<7>). +- async-not-sync : Bool property to control if data is received in asynchronous mode + (all bits/bytes with ts_valid or ts_packet asserted are valid). + +- dvb-card : Describes the NIM card connected to this tsin channel. + +Example: + +/* stih410 SoC b2120 + b2004a + stv0367-pll(NIMB) + stv0367-tda18212 (NIMA) DT example) */ + + c8sectpfe@08a20000 { + compatible = "st,stih407-c8sectpfe"; + status = "okay"; + reg = <0x08a20000 0x10000>, <0x08a00000 0x4000>; + reg-names = "stfe", "stfe-ram"; + interrupts = <0 34 0>, <0 35 0>; + interrupt-names = "stfe-error-irq", "stfe-idle-irq"; + + pinctrl-names = "tsin0-serial", "tsin0-parallel", "tsin3-serial", + "tsin4-serial", "tsin5-serial"; + + pinctrl-0 = <&pinctrl_tsin0_serial>; + pinctrl-1 = <&pinctrl_tsin0_parallel>; + pinctrl-2 = <&pinctrl_tsin3_serial>; + pinctrl-3 = <&pinctrl_tsin4_serial_alt3>; + pinctrl-4 = <&pinctrl_tsin5_serial_alt1>; + + clocks = <&clk_s_c0_flexgen CLK_PROC_STFE>; + clock-names = "stfe"; + + /* tsin0 is TSA on NIMA */ + tsin0: port@0 { + tsin-num = <0>; + serial-not-parallel; + i2c-bus = <&ssc2>; + rst-gpio = <&pio15 4 0>; + dvb-card = ; + }; + + tsin3: port@3 { + tsin-num = <3>; + serial-not-parallel; + i2c-bus = <&ssc3>; + rst-gpio = <&pio15 7 0>; + dvb-card = ; + }; + }; -- cgit 1.2.3-korg