blob: ff2a2e20eae9818ec6b76bd116604f30c961d935 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
|
############################################################################################################################
# Date: <13/01/2017> Version: <1.1> #
############################################################################################################################
Feature:Auth_NotAccept_by_UE_SQN_failure
@authentication-procedure @Auth_NotAccept_by_UE_SQN_failure @TS_24_301 @24_301_5_4_2_6 @24_301_5_4_2_7 @negTCs @Series-0004
Scenario: UE receives an AUTHENTICATION REQUEST message with SQN out of range. UE sends an AUTHENTICATION FAILURE message to the network, with EMM cause "synch failure" and a re-synchronization token. Now UE receives a new correct AUTHENTICATION REQUEST message while T3420 is running. Finally UE sends a correct AUTHENTICATION RESPONSE message.
Given all configured endpoints for SSH are connected successfully
Given the steps below will be executed at the end
When I stop S1AP simulator on node ABOT
When I run the SSH command "sudo service mme_gw restart" on node MME
Given that I setup S1AP Simulator with UE parameter "ABOT.UE.CONFIG.SECURITY.SYNC_FAILURE=false" on node ABOT
Given that I setup S1AP Simulator with USIM parameter "ABOT.UE.USIM.AttachWithImsi=true" on node ABOT
Given the execution is paused for {abotprop.WAIT_10_SEC} seconds
Then the ending steps are complete
# set ABOT configuration
Given that I setup S1AP Simulator with default parameters specified in {abotprop.ABOT.EPC.Defaults} on node ABOT
Given that I setup S1AP Simulator with UE parameter "ABOT.UE.CONFIG.SECURITY.SYNC_FAILURE=true" on node ABOT
Given that I setup S1AP Simulator with USIM parameter "ABOT.UE.USIM.AttachWithImsi=false" on node ABOT
# Execute ABOT S1AP Simulator
When I run S1AP simulator on node ABOT with 1 UE
Given the execution is paused for {abotprop.WAIT_10_SEC} seconds
Given the execution is paused for {abotprop.WAIT_10_SEC} seconds
# Validate Test Case Execution at Simulator
Then I receive S1AP response on node ABOT and verify the presence of all the following values:
| responseResult | existence |
| Send Attach Request message with GUTI | {string:nocase:present} |
| Received Identity Request message | {string:nocase:present} |
| Identification requested type = IMSI | {string:nocase:present} |
| Send Identity Response message | {string:nocase:present} |
| Received Authentication Request message | {string:nocase:present} |
| Send Authentication Failure message (cause=21) | {string:nocase:present} |
| Received Authentication Request message | {string:nocase:present} |
| Send Authentication Response message | {string:nocase:present} |
| Received Security Mode Command message | {string:nocase:present} |
| Send Security Mode Complete message | {string:nocase:present} |
| Received Attach Accept message | {string:nocase:present} |
|