############################################################################################################################
#                                              Date: <31/08/2016> Version: <1.1>                                           #
############################################################################################################################

Feature:Attach_Procedure_Attach_With_GUTI

@attach-procedure @Attach_Procedure_Attach_With_GUTI @TS_24_301 @24_301_5_5 @24_301_5_5_1_2_2 @TS_24_368 @24_368_4 @24_368-5_4 @Series-0000
Scenario: Attach Procedure Success with right GUTI.

Given all configured endpoints for SSH are connected successfully

Given the steps below will be executed at the end
When I stop S1AP simulator on node ABOT
When I run the SSH command "sudo service mme_gw restart" on node MME
Given the execution is paused for {abotprop.WAIT_10_SEC} seconds
Then the ending steps are complete

# set ABOT configuration
Given that I setup S1AP Simulator with default parameters specified in {abotprop.ABOT.EPC.Defaults} on node ABOT
Given that I setup S1AP Simulator with USIM parameter "ABOT.UE.USIM.AttachWithImsi=false" on node ABOT

# Execute ABOT S1AP Simulator
When I run S1AP simulator on node ABOT with 1 UE

Given the execution is paused for {abotprop.WAIT_10_SEC} seconds

# Validate Test Case Execution at Simulator
Then I receive S1AP response on node ABOT and verify the presence of all the following values:
| responseResult                          | existence               |
| Send Attach Request message with GUTI   | {string:nocase:present} |
| Received Authentication Request message | {string:nocase:present} |
| Send Authentication Response message    | {string:nocase:present} |
| Received Security Mode Command message  | {string:nocase:present} |
| Send Security Mode Complete message     | {string:nocase:present} |
| Received Attach Accept message          | {string:nocase:present} |